M28529G-12 Mindspeed Technologies, M28529G-12 Datasheet - Page 212

• Manufacturer Part Number: M28529G-12
• Description: ATM IMA 8.192Mbps 1.8V/3.3V 484-Pin BGA
• Manufacturer: Mindspeed Technologies

Specifications of M28529G-12

• Package: 484BGA
• Utopia Type: Level 2
• Typical Operating Supply Voltage: 1.8|3.3 V
• Minimum Operating Supply Voltage: 1.71|3.135 V
• Maximum Operating Supply Voltage: 1.89|3.465 V
• Maximum Output Rate: 8.192 Mbps

2.4.18
2.4.19
This register configures the operation of the ATM side UTOPIA bus and the sample time of PhyUTxClAv for an IMA
group.
28529-DSH-001-K
Footnote:
(1) The Alpha Value is the number of consecutive invalid ICP cells needed for the link to leave the IMA Sync state.
(2) The Beta Value is the number of consecutive errored ICP cells needed for the link to leave the IMA Sync state.
(3) The Gamma Value is the number of consecutive valid ICP cells needed for the link to enter the IMA Sync state.
5–3
2–0
Bit
Bit
7
6
7
6
5
4
3
2
1
0
Default
Default
—
0
0
0
0
0
0
0
0
0
0
0
0x812—IMA_RX_PERSIST_CONFIG (IMA Receive Persistence
Configuration)
0x813—IMA_ATM_UTOPIA_BUS_CTL (IMA ATM UTOPIA Bus Control)
Alpha Value
Beta Value
Gamma Value
ATM Address Mode
ATMURxClAv Mode
ATMUTxClAv Last 4
Bytes/Words Mode
ATMUTxClAv Mode
ClAv Three-state Disable 0 = ATMURxClAv and ATMUTxClAv threestate when not selected
PHYUTxClAv Sample
Time
Name
Name
(2)
—
—
—
(1)
(3)
Mindspeed Proprietary and Confidential
Mindspeed Technologies
Reserved. Set to 0.
0: α = 1
1: α = 2
0: β = 1
1: β = 2
2: β = 3
3: β = 4
4: β = 5
0: γ = 1
1: γ = 2
2: γ = 3
3: γ = 4
4: γ = 5
Reserved. Set to 0.
0 = UTOPIA Level 2 (multiple addresses)
1 = UTOPIA Level 1 (single fixed address, no address latching)
Reserved. Set to 0.
0 = ATMURxClAv is set active for selected channel during cell transfer
1 = ATMURxClAv is set inactive for selected channel during cell transfer
0 = ATMUTxClAv is forced inactive/active (based on the state of bit 2) during last 4 bytes/words
for selected channel during cell transfer
1 = ATMUTxClAv reflects true cell available status during last 4 bytes/words for selected channel
during cell transfer
0 = ATMUTxClAv is set inactive for selected channel during cell transfer
1 = ATMUTxClAv is set active for selected channel during cell transfer
1 = ATMURxClAv and ATMUTxClAv do not threestate
0 = For an IMA group, sample PhyUTxClAv during an ICP cell to determine SICP rate
1 = For an IMA group, delay sampling PhyUTxClAv until >5 payload byte periods after an ICP
transfer
®
Description
Description
Registers
197