SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 385

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

29.8.2.3
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
Signal Multiplexing
Figure 29-6.
Depending on the BAT, only the write signals or the byte select signals are used. To save IOs at
the external bus interface, control signals at the SMC interface are multiplexed.
shows signal multiplexing depending on the data bus width and the byte access type.
For 32-bit devices, bits A0 and A1 are unused. For 16-bit devices, bit A0 of address is unused.
When Byte Select Option is selected, NWR1 to NWR3 are unused. When Byte Write option is
selected, NBS0 to NBS3 are unused.
Connection of 2 x 8-bit Devices on a 16-bit Bus: Byte Write Option
SMC
D[15:8]
NCS[3]
A[24:2]
D[7:0]
NWR0
NWR1
NRD
A1
A[23:1]
A[0]
Write Enable
Read Enable
Memory Enable
D[15:8]
A[23:1]
A[0]
Write Enable
Read Enable
Memory Enable
D[7:0]
SAM9G35
SAM9G35
Table 29-3
385
385