SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 956

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

• TSSCTIM: Touchscreen Switches Closure Time
Defines closure time of analog switches necessary to establish the measurement conditions.
The Closure Time is:
Switch Closure Time = (TSSCTIM * 4) ADCClock periods.
• PENDET: Pen Contact Detection Enable
0: Pen contact detection disable.
1: Pen contact detection enable.
When PENDET = 1, XPOS, YPOS, Z1, Z2 values of ADC_XPOSR, ADC_YPOSR, ADC_PRESSR registers are automati-
cally cleared when PENS = 0 in ADC_ISR.
• NOTSDMA: No TouchScreen DMA
0: XPOS, YPOS, Z1, Z2 are transmitted in ADC_LCDR.
1: XPOS, YPOS, Z1, Z2 are never transmitted in ADC_LCDR, therefore the buffer does not contains touchscreen values.
• PENDBC: Pen Detect Debouncing Period
PENDBC
Debouncing period = 2
ADCClock periods.
SAM9G35
956
11053B–ATARM–22-Sep-11