ST7DALIF2 STMicroelectronics, ST7DALIF2 Datasheet - Page 61

• Manufacturer Part Number: ST7DALIF2
• Description: 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI
• Manufacturer: STMicroelectronics

Specifications of ST7DALIF2

• 8 Kbytes Single Voltage Flash Program Memory With Read-out Protection, In-circuit Programming And In-application Programming (icp And Iap). 10k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55°C.
• 256 Bytes Data Eeprom With Read-out Protection. 300k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55°C.
• Clock Sources: Internal 1% RC oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-Halt, Wait and Slow, Auto Wake Up From Halt

ST7DALIF2
12
12.1
12.2
12.2.1
Note:
1
2
I/O ports
Introduction
The I/O ports allow data transfer. An I/O port can contain up to 8 pins. Each pin can be
programmed independently either as a digital input or digital output. In addition, specific pins
may have several other functions. These functions can include external interrupt, alternate
signal input/output for on-chip peripherals or analog input.
Functional description
A Data Register (DR) and a Data Direction Register (DDR) are always associated with each
port. The Option Register (OR), which allows input/output options, may or may not be
implemented. The following description takes into account the OR register. Refer to the Port
Configuration table for device specific information.
An I/O pin is programmed using the corresponding bits in the DDR, DR and OR registers: bit
x corresponding to pin x of the port.
Figure 30
Input modes
Clearing the DDRx bit selects input mode. In this mode, reading its DR bit returns the digital
value from that I/O pin.
If an OR bit is available, different input modes can be configured by software: floating or pull-
up. Refer to I/O Port Implementation section for configuration.
Writing to the DR modifies the latch value but does not change the state of the input pin.
Do not use read/modify/write instructions (BSET/BRES) to modify the DR register.
External interrupt function
Depending on the device, setting the ORx bit while in input mode can configure an I/O as an
input with interrupt. In this configuration, a signal edge or level input on the I/O generates an
interrupt request via the corresponding interrupt vector (eix).
Falling or rising edge sensitivity is programmed independently for each interrupt vector. The
External interrupt control register (EICR) on page 48
Each external interrupt vector is linked to a dedicated group of I/O port pins (see
Pin description on page 13
If several I/O interrupt pins on the same interrupt vector are selected simultaneously, they
are logically combined. For this reason if one of the interrupt pins is tied low, it may mask the
others.
External interrupts are hardware interrupts. Fetching the corresponding interrupt vector
automatically clears the request latch. Changing the sensitivity of a particular external
interrupt clears this pending interrupt. This can be used to clear unwanted pending
interrupts.
Spurious interrupts
shows the generic I/O block diagram.
and
Section 10: Interrupts on page
controls this sensitivity.
45).
Section 4:
I/O ports
61/171