at91sam9263 ATMEL Corporation, at91sam9263 Datasheet - Page 526

• Manufacturer Part Number: at91sam9263
• Description: At91 Arm Thumb Microcontrollers
• Manufacturer: ATMEL Corporation

Figure 33-17. Connection with a Remote Device for Hardware Handshaking
Figure 33-18. Receiver Behavior when Operating with Hardware Handshaking
Figure 33-19. Transmitter Behavior when Operating with Hardware Handshaking
6249D–ATARM–20-Dec-07
RXBUFF
US_CR
Write
RXD
RTS
RXEN = 1
Setting the USART to operate with hardware handshaking is performed by writing the
USART_MODE field in the Mode Register (US_MR) to the value 0x2.
The USART behavior when hardware handshaking is enabled is the same as the behavior in
standard synchronous or asynchronous mode, except that the receiver drives the RTS pin as
described below and the level on the CTS pin modifies the behavior of the transmitter as
described below. Using this mode requires using the PDC channel for reception. The transmitter
can handle hardware handshaking in any case.
Figure 33-18
pin is driven high if the receiver is disabled and if the status RXBUFF (Receive Buffer Full) com-
ing from the PDC channel is high. Normally, the remote device does not start transmitting while
its CTS pin (driven by RTS) is high. As soon as the Receiver is enabled, the RTS falls, indicating
to the remote device that it can start transmitting. Defining a new buffer to the PDC clears the
status bit RXBUFF and, as a result, asserts the pin RTS low.
Figure 33-19
pin disables the transmitter. If a character is being processing, the transmitter is disabled only
after the completion of the current character and transmission of the next character happens as
soon as the pin CTS falls.
CTS
TXD
USART
shows how the transmitter operates if hardware handshaking is enabled. The CTS
shows how the receiver operates if hardware handshaking is enabled. The RTS
RXD
TXD
CTS
RTS
AT91SAM9263 Preliminary
RXD
TXD
RTS
CTS
Remote
Device
RXDIS = 1
526