C505_9708 SIEMENS [Siemens Semiconductor Group], C505_9708 Datasheet - Page 77

• Manufacturer Part Number: C505_9708
• Description: 8-Bit CMOS Microcontroller
• Manufacturer: SIEMENS [Siemens Semiconductor Group]

6.2
The C505 contains three 16-bit timers/counters, timer 0, 1, and 2, which are useful in many
applications for timing and counting.
In "timer" function, the timer register is incremented every machine cycle. Thus one can think of it
as counting machine cycles. Since a machine cycle consists of 6 oscillator periods, the counter rate
is 1/6 of the oscillator frequency.
In "counter" function, the timer register is incremented in response to a 1-to-0 transition (falling
edge) at its corresponding external input pin, T0, T1, or T2 (alternate functions of P3.4, P3.5 and
P1.7 resp.). In this function the external input is sampled during S5P2 of every machine cycle. When
the samples show a high in one cycle and a low in the next cycle, the count is incremented. The
new count value appears in the register during S3P1 of the cycle following the one in which the
transition was detected. Since it takes two machine cycles (12 oscillator periods) to recognize a 1-
to-0 transition, the maximum count rate is 1/12 of the oscillator frequency. There are no restrictions
on the duty cycle of the external input signal, but to ensure that a given level is sampled at least
once before it changes, it must be held for at least one full machine cycle.
6.2.1
Timer / counter 0 and 1 of the C505 are fully compatible with timer / counter 0 and 1 of the C501
and can be used in the same four operating modes:
Mode 0: 8-bit timer/counter with a divide-by-32 prescaler
Mode 1: 16-bit timer/counter
Mode 2: 8-bit timer/counter with 8-bit auto-reload
Mode 3: Timer/counter 0 is configured as one 8-bit timer/counter and one 8-bit timer; Timer/
External inputs INT0 and INT1 can be programmed to function as a gate for timer/counters 0 and 1
to facilitate pulse width measurements.
Each timer consists of two 8-bit registers (TH0 and TL0 for timer/counter 0, TH1 and TL1 for timer/
counter 1) which may be combined to one timer configuration depending on the mode that is
established. The functions of the timers are controlled by two special function registers TCON and
TMOD.
In the following descriptions the symbols TH0 and TL0 are used to specify the high-byte and the
low-byte of timer 0 (TH1 and TL1 for timer 1, respectively). The operating modes are described and
shown for timer 0. If not explicity noted, this applies also to timer 1.
Semiconductor Group
Timers/Counters
Timer/Counter 0 and 1
counter 1 in this mode holds its count. The effect is the same as setting TR1 = 0.
6-15
On-Chip Peripheral Components
C505 / C505C
1997-08-01