Z8F082A28100KIT ZILOG [Zilog, Inc.], Z8F082A28100KIT Datasheet - Page 107

• Manufacturer Part Number: Z8F082A28100KIT
• Description: Z8 Encore XP-R F08xA Series with eXtended Peripherals
• Manufacturer: ZILOG [Zilog, Inc.]

PS024705-0405
Receiving Data using the Interrupt-Driven Method
The UART Receiver interrupt indicates the availability of new data (as well as error condi-
tions). Follow these steps to configure the UART receiver for interrupt-driven operation:
1. Write to the UART Baud Rate High and Low Byte registers to set the acceptable baud
2. Enable the UART pin functions by configuring the associated GPIO Port pins for
3. Execute a DI instruction to disable interrupts.
4. Write to the Interrupt control registers to enable the UART Receiver interrupt and set
5. Clear the UART Receiver interrupt in the applicable Interrupt Request register.
6. Write to the UART Control 1 Register to enable Multiprocessor (9-bit) mode
7. Write the device address to the Address Compare Register (automatic
8. Write to the UART Control 0 register to:
9. Execute an EI instruction to enable interrupts.
The UART is now configured for interrupt-driven data reception. When the UART
Receiver interrupt is detected, the associated interrupt service routine (ISR) performs the
following:
1. Checks the UART Status 0 register to determine the source of the interrupt - error,
2. Reads the data from the UART Receive Data register if the interrupt was because of
3. Clears the UART Receiver interrupt in the applicable Interrupt Request register.
rate.
alternate function operation.
the acceptable priority.
functions, if appropriate.
–
–
–
MULTIPROCESSOR modes only).
–
–
break, or received data.
data available. If operating in MULTIPROCESSOR (9-bit) mode, further actions may
be required depending on the MULTIPROCESSOR mode bits MPMD[1:0].
Set the Multiprocessor Mode Select (MPEN) to Enable MULTIPROCESSOR
mode.
Set the Multiprocessor Mode Bits, MPMD[1:0], to select the acceptable address
matching scheme.
Configure the UART to interrupt on received data and errors or errors only
(interrupt on errors only is unlikely to be useful for Z8 Encore!
DMA block)
Set the receive enable bit (REN) to enable the UART for data reception
Enable parity, if appropriate and if multiprocessor mode is not enabled, and select
either even or odd parity.
P R E L I M I N A R Y
Z8 Encore! XP
Product Specification
®
®
devices without a
F08xA Seriess
UART
89