Z8F082A28100KIT ZILOG [Zilog, Inc.], Z8F082A28100KIT Datasheet - Page 42

• Manufacturer Part Number: Z8F082A28100KIT
• Description: Z8 Encore XP-R F08xA Series with eXtended Peripherals
• Manufacturer: ZILOG [Zilog, Inc.]

STOP Mode Recovery
PS024705-0405
External Reset Indicator
On-Chip Debugger Initiated Reset
and as long as four. A reset pulse three clock cycles in duration might trigger a reset; a
pulse four cycles in duration always triggers a reset.
While the RESET input pin is asserted Low, the Z8 Encore! XP
remain in the Reset state. If the RESET pin is held Low beyond the System Reset time-
out, the device exits the Reset state on the system clock rising edge following RESET pin
deassertion. Following a System Reset initiated by the external RESET pin, the EXT sta-
tus bit in the Watch-Dog Timer Control (WDTCTL) register is set to 1.
During System Reset or when enabled by the GPIO logic (see
isters” on page 38.
indicator in addition to the input functionality. This reset output feature allows an Z8
Encore! XP
even if that reset is caused by internal sources such as POR, VBO or WDT events.
After an internal reset event occurs, the internal circuitry begins driving the RESET pin
Low. The RESET pin is held Low by the internal circuitry until the appropriate delay
listed in Table 8 has elapsed.
A Power-On Reset can be initiated using the On-Chip Debugger by setting the
the OCD Control register. The On-Chip Debugger block is not reset but the rest of the chip
goes through a normal system reset. The
reset. Following the system reset the
STOP mode is entered by execution of a STOP instruction by the eZ8 CPU. Refer to the
chapter
STOP Mode Recovery, the CPU is held in reset for 66 IPO cycles if the crystal oscillator is
disabled or 5000 cycles if it is enabled.
STOP Mode Recovery does not affect onchip registers other than the Watchdog Timer
Control register (WDTCTL) and the Oscillator Control register (OSCCTL). After any
STOP Mode Recovery, the IPO is enabled and selected as the system clock. If another sys-
tem clock source is required or IPO disabling is required, the STOP Mode Recovery code
must reconfigure the oscillator control block such that the correct system clock source is
enabled and selected.
The eZ8 CPU fetches the Reset vector at Program Memory addresses
and loads that value into the Program Counter. Program execution begins at the Reset vec-
tor address. Following STOP Mode Recovery, the STOP bit in the Watch-Dog Timer Con-
“Low-Power Modes” on page 28
®
F08xA Series device to reset other components to which it is connected,
), the RESET pin functions as an open-drain (active low) reset mode
P R E L I M I N A R Y
POR
for detailed STOP mode information. During
RST
bit in the WDT Control register is set.
bit automatically clears during the system
Z8 Encore! XP
Reset and STOP Mode Recovery
See “Port A–D Control Reg-
®
Product Specification
F08xA Series devices
0002H
®
F08xA Series
and
RST
0003H
bit in
24