Z8FMC04100 ZILOG [Zilog, Inc.], Z8FMC04100 Datasheet - Page 94

• Manufacturer Part Number: Z8FMC04100
• Description: Z8 Encore-R Motor Control Flash MCUs
• Manufacturer: ZILOG [Zilog, Inc.]

72
Z8 Encore!
Product Specification
Pulse-Width Modulator
PWM Duty Cycle Registers
Independent and Complementary PWM Outputs
Manual Off-State Control of PWM Output Channels
Deadband Insertion
®
Motor Control Flash MCUs
The PWM Duty Cycle registers (PWM0HD, PWM0LD, PWM1HD, PWM1LD,
PWM2HD, PWM2LD) contain a 16-bit signed value, in which bit 15 is the sign bit. The
Duty Cycle value is compared to the current 12-bit unsigned PWM count value. If the
PWM Duty Cycle value is set less than or equal to 0, the PWM output is deasserted for the
full PWM period. If the PWM Duty Cycle value is set to a value greater than the PWM
reload value, the PWM output is asserted for the full PWM period.
The six PWM outputs are configurable to operate independently, or as three complemen-
tary pairs. Operation as six independent PWM channels is enabled by setting the INDEN
bit in the PWM Control 1 Register (PWMCTL1). The
this bit. In independent mode, each PWM output uses its own PWM duty cycle value.
When configured to operate as three complementary pairs, the PWM duty cycle values
PWM0HD, PWM1HD, and PWM2HD control the modulator output. In complementary
output mode, deadband time is also inserted.
The POLx bits in the PWM Control 1 Register (PWMCTL1) select the relative polarity of
the High and Low signals. As illustrated in
cleared to 0, the High PWM output will start in the ON state and transition to the OFF
state when the PWM timer count reaches the programmed duty cycle. The Low PWM
value starts in the OFF state and transitions to the ON state as the PWM timer count
reaches the value in the associated duty cycle register. Alternately, setting the POLx
causes the High output to start in the OFF state and the Low output to start in the ON state.
Each PWM output can be controlled directly by the modulator logic or set to the OFF
state. To manually set the PWM outputs to the OFF state, set the
ciated
operates individually by channel. For example, suppressing the single output of a pair
allows the complementary channel to continue operating. Similarly, if the outputs are
operating independently, disabling one output channel has no effect on the other PWM
outputs.
When the PWM outputs are configured to operate as complementary pairs, an 8-bit dead-
band value can be defined in the PWM Deadband Register (PWMDB). Inserting deadband
time causes the modulator to separate the deassertion of one PWM signal from the asser-
tion of its complement. This separation is essential for many motor control applications in
that it prevents simultaneous turn-on of the High and Low drive transistors. The deadband
OUTx
bits in the PWM Output Control Register (PWMOUT). OFF state control
P R E L I M I N A R Y
Figures 8 and
PWEN
9, when the POLx bits are
bit must be cleared to alter
OUTCTL
bit and the asso-
PS024604-1005