MT312C ZARLINK [Zarlink Semiconductor Inc], MT312C Datasheet - Page 39

no-image

MT312C

Manufacturer Part Number
MT312C
Description
Satellite Channel Decoder
Manufacturer
ZARLINK [Zarlink Semiconductor Inc]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MT312C
Manufacturer:
ZARLINK
Quantity:
20 000
Part Number:
MT312C CG
Manufacturer:
MICRON
Quantity:
13
Part Number:
MT312CCG
Manufacturer:
ZARLINK
Quantity:
20 000
The Viterbi decoder will search for a signal with the code rates selected by this register. If one code rate is
selected, the MT312 will search for a signal with only that code rate. If the code rate is unknown then all B5:0
may be set, when the MT312 will search all code rates. It is possible to choose the starting point for the code
rate search by setting a bit in VIT SETUP[B3:1] register (86). After searching for a signal with the initial code
rate, if no signal is found the search proceeds to the next higher code rate, see 69.
In the DSS mode the code rate is not specified using VIT MODE register. If any of the two DSS bits of
Configuration Register (127) is set, then the code rates selected by the VIT MODE register are ignored. The
DSS code rate selection is carried out as described in section 1.1, see 10.
The result of the search is reported in the FEC STAT register (6), see 49.
6.1.3 QPSK Control. Register 26 (R/W)
B7:
B6:
B5:
B4:
B3:
B2:
B1:
B0:
If any of the two DSS control bits of the Configuration Register (127) is active (see section 1.1 10), then bit B0
(ROLL 20) is ignored and the matched filter root-raised-cosine roll-off factor is taken as 0.20. Hence bit only
allows the choice of roll-off in the DVB mode.
NAME
QPSK
CTRL
Reserved
Q IQ SP
Reserved
Reserved
Reserved
AFC M
Reserved
ROLL 20
ADR
26
Reserved
B7
Must be set low.
Swap I and Q inputs before QPSK demodulation to overcome spectral inversion
caused by the receiver front-end, for example through the swapping I and Q wires on
the board.
High = I-Q swap
Low = No I-Q swap
Must be set low.Q MANHigh = QPSK manual programming
Must be set low.OP CALHigh = Output calculation disable
Must be set low.FLD LKHigh = Use Frequency Lock Detector lock
High = Use AFC mode, for low Symbol rates only, < 10MSym/s.
Must be set low.
High = Roll-off 0.20
Low = Roll-off 0.35
IQ SP
B6
Q
Reserved Reserved Reserved AFC
B5
B4
B3
QPSK Demodulator
B2
M
Reserved ROLL
B1
B0
20
R/W
MT312
hex
Def
00
39

Related parts for MT312C