MT312C ZARLINK [Zarlink Semiconductor Inc], MT312C Datasheet - Page 54

• Manufacturer Part Number: MT312C
• Description: Satellite Channel Decoder
• Manufacturer: ZARLINK [Zarlink Semiconductor Inc]

MT312
9 MPEG Packet Data Ouput
9.1 MPEG Clock Modes
There are four MOCLK modes of operation, controlled by register bits.
9.1.1 MANUAL MOCLK = 0 and DIS SR = 0.
In this mode MOCLK is generated from the symbol clock . MOCLK will be a continuously running clock once
symbol lock has been achieved in the QPSK block.
9.1.2 MANUAL MOCLK = 0 and DIS SR = 1.
In this mode MOCLK is not generated from the symbol clock but instead uses the data in the QPSK decimation
ratio. This mode is not normally used but is available for engineering test purposes.
9.1.3 MANUAL MOCLK = 1 and DIS SR = 0.
This is the Programmable Clock Division Ratio mode of operation. MOCLK is generated by dividing the PLL
clock frequency by the MOCLK RATIO + 6 see register 33 on 47.
MOCLK frequency =
The range of values of 6 to 9 for (MOCLK RATIO + 6) will guarantee operation for 2 - 45 MSym/s. However, for
a restricted range of symbol rates, higher (MOCLK RATIO + 6) values may be used with a lower MOCLK
frequency. The equation in section 9.4 on 58 must be evaluated to ensure successful operation and avoid
buffer overflow in the MT312.
54
MANUAL MOCLK
register 96 bit 7
PLL frequency
60MHz
60MHz
90MHz
90MHz
0
0
1
1
MPEG Packet Data Output
Table 6 - MOCLK input minimum and maximum frequencies
--------------------------------------------------- -
(MCLK_RATIO + 6)
PLLfrequency
register 97 bit 7
MOCLK RATIO + 6
DIS SR
0
1
0
1
Table 5 - MPEG clock modes
6
9
6
9
Disable use of Symbol Rate for MOCLK generation.
Manually set MOCLK period from MOCLK RATIO
Use external MICLK (pin 14) signal for MOCLK.
Use Symbol Rate for MOCLK generation.
MOCLK frequency
6.667 MHz
10.0MHz
10.0MHz
15MHz
MOCLK generation mode
(reg. 33).
comment
maximum
maximum
minimum
minimum