MPC8572CLPXARLD FREESCALE [Freescale Semiconductor, Inc], MPC8572CLPXARLD Datasheet - Page 117

• Manufacturer Part Number: MPC8572CLPXARLD
• Description: MPC8572E PowerQUICC III Integrated Processor Hardware Specifications
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Freescale Semiconductor
25. When operating in DDR2 mode, connect Dn_MDIC[0] to ground through 18.2-Ω (full-strength mode) or 36.4-Ω (half-strength
26. These pins should be connected to XVDD_SRDS1.
27. These pins should be pulled to ground (XGND_SRDS1) through a 300-Ω (±10%) resistor.
28. These pins should be left floating.
29. These pins should be pulled up to TVDD through a 2–10 KΩ resistor.
30. These pins have other manufacturing or debug test functions. It is recommended to add both pull-up resistor pads to OVDD
31. DDRCLK input is only required when the MPC8572E DDR controller is running in asynchronous mode. When the DDR
32. EC_GTX_CLK125 is a 125-MHz input clock shared among all eTSEC ports in the following modes: GMII, TBI, RGMII and
33. These pins should be pulled to ground (GND).
34. These pins are sampled at POR for General Purpose configuration use by software. Their value has no impact on the
RTBI. If none of the eTSEC ports is operating in these modes, the EC_GTX_CLK125 input can be tied off to GND.
functionality of the hardware.
mode) precision 1% resistor, and connect Dn_MDIC[1] to GVDD through 18.2-Ω (full-strength mode) or 36.4-Ω
(half-strength mode) precision 1% resistor. When operating in DDR3 mode, connect Dn_MDIC[0] to ground through 20-Ω
(full-strength mode) or 40-Ω (half-strength mode) precision 1% resistor, and connect Dn_MDIC[1] to GVDD through 20-Ω
(full-strength mode) or 40-Ω (half-strength mode) precision 1% resistor. These pins are used for automatic calibration of the
DDR IOs.
controller is configured to run in synchronous mode via POR setting cfg_ddr_pll[0:2]=111, the DDRCLK input is not
required. It is recommended to tie it off to GND when DDR controller is running in synchronous mode. See the MPC8572E
PowerQUICC™ III Integrated Host Processor Family Reference Manual Rev.0, Table 4-3 in section 4.2.2 “Clock Signals”,
section 4.4.3.2 “DDR PLL Ratio” and Table 4-10 “DDR Complex Clock PLL Ratio” for more detailed description regarding
DDR controller operation in asynchronous and synchronous modes.
and pull-down resistor pads to GND on board to support future debug testing when needed.
Signal
MPC8572E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 4
Table 75. MPC8572E Pinout Listing (continued)
Signal Name
Package Pin Number
Pin Type
Supply
Power
Package Description
Notes
117