HD6417708SF60 Renesas Electronics America, HD6417708SF60 Datasheet - Page 275

• Manufacturer Part Number: HD6417708SF60
• Description: IC SUPERH MPU ROMLESS 144LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417708SF60

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 60MHz
• Connectivity: EBI/EMI, SCI, SmartCard
• Peripherals: POR, WDT
• Number Of I /o: 8
• Program Memory Type: ROMless
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Ram Size: -
• Program Memory Size: -
• Data Converters: -

10.3.5
Synchronous DRAM Interface
Synchronous DRAM Direct Connection: Since synchronous DRAM can be selected by the CS
signal, physical space areas 2 and 3 can be connected using RAS and other control signals in
common. If the memory type bits (DRAMTP2–DRAMTP0) in BCR1 are set to 010, area 2 is
normal memory space and area 3 is synchronous DRAM space; if set to 011, areas 2 and 3 are
both synchronous DRAM space.
With the SH7708 Series, burst length 1 burst read/single write mode is supported as the
synchronous DRAM operating mode. The data bus width is fixed at 32 bits, and the size bit (SZ)
in MCR must be set to 1. The burst enable bit (BE) in MCR is ignored, a16-bit burst transfer is
performed in a cache fill/copy-back cycle, and only one access is performed in a write-through
area write or a noncacheable area read/write.
The control signals for direct connection of synchronous DRAM are RAS, CAS, RD/WR, CS2 or
CS3, DQMUU, DQMUL, DQMLU, DQMLL, and CKE. All the signals other than CS2 and CS3
are common to all areas, and signals other than CKE are valid and fetched to the synchronous
DRAM only when CS2 or CS3 is asserted. Synchronous DRAM can therefore be connected in
parallel to a number of areas. CKE is negated (low) only when self-refreshing is performed,
otherwise it is asserted (high).
Commands for synchronous DRAM are specified by RAS, CAS, RD/WR, and special address
signals. The commands are NOP, auto-refresh (REF), self-refresh (SELF), precharge all banks
(PALL), precharge specified bank (P RE), row address strobe bank active (ACTV), read (READ),
read with precharge (READA), write (WRIT), write with precharge (WRITA), and mode register
write (MRS).
Byte specification is performed by DQMUU, DQMUL, DQMLU, and DQMLL. A read/write is
performed for the byte for which the corresponding DQM is low. In big-endian mode, DQMUU
specifies an access to address 4n, and DQMLL specifies an access to address 4n + 3. In little-
endian mode, DQMUU specifies an access to address 4n + 3, and DQMLL specifies an access to
address 4n.
Figure 10.23 shows an example of the connection of 256k
16-bit synchronous DRAMs.
255