XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 127
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
XW2Z-200J-B9
Manufacturer Part Number
XW2Z-200J-B9
Description
CONNECTOR CABLE 2M
Manufacturer
Omron
Datasheet
1.XW2Z-200J-C1.pdf
(504 pages)
Specifications of XW2Z-200J-B9
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
XW2Z200JB9
- Current page: 127 of 504
- Download datasheet (9Mb)
Module Wiring
3-2-4
Available Connectors
100
Wiring CJ-series I/O Units with Connectors
Note
This section describes wiring for the following Units:
CJ-series Basic I/O Units with connectors use special connectors to connec-
tor to external I/O devices. The user can combine a special connector with
cable or use a pre-assembled OMRON cable to connect to a terminal block or
I/O Terminal. The available OMRON cables are described later in this section.
Use the following connectors when assembling a connector and cable.
(1) Be sure not to apply a voltage that exceeds the input voltage for Input
(2) When the power supply has positive and negative terminals, be sure to
(3) Use reinforced insulation or double insulation on the DC power supply
(4) When connecting the connector to the I/O Unit, tighten the connector
(5) Turn on the power after checking the connector’s wiring.
(6) Do not pull the cable. Doing so may disconnect or damage the cable.
(7) Do not bend the cable too sharply. Doing so may damage or break wiring
(8) CJ-series Basic I/O Units with 32 or 64-point Fujitsu connectors have the
• The lead wires do not have to be removed from the terminal block to
• CJ-series Basic I/O Units with Connectors (32- and 64-point Units)
remove it from an I/O Unit.
CJ-series Basic I/O Unit
OD2 11
Units or the maximum switching capacity for Output Units.
wire them correctly
connected to DC I/O Units when required by EC Directives (low voltage).
screws to a torque of 0.2 N • m.
in the cable.
same connector pin allocations as the C200H High-density I/O Units and
CS-series I/O Units with connectors to make them compatible.
Terminal block lever
Section 3-2