XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 238

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

Checking for High-speed
Counter Interrupts
Pulse Inputs
Target value
Target value
Target value
Target value
Target value
Target values
for comparison
Counter PV
3
2
4
1
5
0
1
Note
2
Target-value Comparison Method
Range Comparison Method
The High-speed Counter Reset Bits are as follows:
The High-speed Counter Reset Bits are refreshed only once each cycle, so a
Reset Bit must be ON for a minimum of 1 cycle to be read reliably.
The comparison table registration and comparison execution status will not be
changed even if the PV is reset. If a comparison was being executed before
the reset, it will continue.
The following two methods are available to check the PV of high-speed
counters 1 or 2.
Up to 48 target values and corresponding interrupt task numbers can be reg-
istered in the comparison table. When the counter PV matches one of the 48
registered target values, the specified interrupt task will be executed.
Comparisons are made to each target value in the order that they appear in
the comparison table until all values have been met, and then comparison will
return to the first value in the table.
Up to 16 comparison ranges (lower and upper limit values) and corresponding
output bit patterns can be registered in the comparison table. When the PV of
the counter first is within the upper and lower limits of one of the ranges for
CTBL(882) execution, the corresponding bit pattern (1 to 16) will be output to
A863 or A865.
Counter 1 or 2
Reset Bit for
High-speed
• High-speed Counter 1 Reset Bit: A860.01
• High-speed Counter 2 Reset Bit: A861.01
• Target-value comparison method
• Range comparison method
3
4
Within 1 cycle
Reset by cycle.
5
1 or more cycles
1
: Interrupt
Elapsed time
(seconds)
Comparison table
Target value
Target value
Target value
Target value
Target value
Section 7-5
1
2
3
4
5
211