ATmega64 Atmel Corporation, ATmega64 Datasheet - Page 291

• Manufacturer Part Number: ATmega64
• Manufacturer: Atmel Corporation

Specifications of ATmega64

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 53
• Ext Interrupts: 8
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 4
• Output Compare Channels: 8
• Input Capture Channels: 2
• Pwm Channels: 7
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Fuse Bits
2490Q–AVR–06/10
Table 116. Lock Bit Protection Modes
Notes:
The ATmega64 has three fuse bytes.
all the fuses and how they are mapped into the fuse bytes. Note that the fuses are read as logi-
cal zero, “0”, if they are programmed.
Table 117. Extended Fuse Byte
Notes:
Fuse Ext Byte
–
–
–
–
–
–
M103C
WDTON
1
2
3
4
Memory Lock Bits
(1)
1. Program the Fuse bits before programming the Lock bits.
2. “1” means unprogrammed, “0” means programmed
1. See
2. See
(2)
“ATmega103 and ATmega64 Compatibility” on page 4
“WDTCR – Watchdog Timer Control Register” on page 57
1
1
0
0
Bit no
7
6
5
4
3
2
1
0
1
0
0
1
Description
–
–
–
–
–
–
ATmega103 compatibility mode
Watchdog Timer always on
Protection Type
No restrictions for SPM or LPM accessing the Boot Loader
section.
SPM is not allowed to write to the Boot Loader section.
SPM is not allowed to write to the Boot Loader section,
and LPM executing from the Application section is not
allowed to read from the Boot Loader section. If Interrupt
Vectors are placed in the Application section, interrupts
are disabled while executing from the Boot Loader section.
LPM executing from the Application section is not allowed
to read from the Boot Loader section. If Interrupt Vectors
are placed in the Application section, interrupts are
disabled while executing from the Boot Loader section.
(2)
Table 117
(Continued)
-
Table 119
describe briefly the functionality of
for details.
Default Value
1
1
1
1
1
1
0 (programmed)
1 (unprogrammed)
for details.
ATmega64(L)
291