SC2200 NSC [National Semiconductor], SC2200 Datasheet - Page 161

• Manufacturer Part Number: SC2200
• Description: Thin Client On a Chip
• Manufacturer: NSC [National Semiconductor]

Revision 3.0
Core Logic Module
5.2.6
The Core Logic module integrates:
• Two 8237-equivalent DMA controllers with full 32-bit
• Two 8259A-equivalent interrupt controllers providing 13
• An 8254-equivalent timer for refresh, timer, and speaker
• NMI control and generation for PCI system errors and all
• Support for standard AT keyboard controllers
• Positive decode for the AT I/O register space
• Reset control
5.2.6.1
The Core Logic module supports industry standard DMA
architecture using two 8237-compatible DMA controllers in
cascaded configuration. The DMA functions supported by
the Core Logic module include:
• Standard seven-channel DMA support
• 32-bit address range support via high page registers
• IOCHRDY extended cycles for compatible timing trans-
• Internal Sub-ISA bus master device support using
• NMI control and generation for PCI system errors and all
ROMCS#, DOCCS#,
addressing
individually programmable external interrupts
logic
parity errors
fers
cascade mode
parity errors.
DEVSEL#,STOP#
IOCS0#, IOCS1#
TRDY#, IRDY#
AT Compatibility Logic
DMA Controller
C/BE[3:0]#
AD[31:0],
FRAME#
GNT[x]
PAR,
(Continued)
PCI
Figure 5-6. PCI Change to Sub-ISA and Back
pull-up
T
CS
161
Note:
DMA Controllers
The Core Logic module supports seven DMA channels
using two standard 8237-equivalent controllers. DMA Con-
troller 1 contains Channels 0 through 3 and supports 8-bit
I/O adapters. These channels are used to transfer data
between 8-bit peripherals and PCI memory or 8/16-bit ISA
memory. Using the high and low page address registers, a
full 32-bit PCI address is output for each channel so they
can all transfer data throughout the entire 4 GB system
address space. Each channel can transfer data in 64 KB
pages.
DMA Controller 2 contains Channels 4 through 7. Channel
4 is used to cascade DMA Controller 1, so it is not available
externally. Channels 5 through 7 support 16-bit I/O adapt-
ers to transfer data between 16-bit I/O adapters and 16-bit
system memory. Using the high and low page address reg-
isters, a full 32-bit PCI address is output for each channel
so they can all transfer data throughout the entire 4 GB
system address space. Each channel can transfer data in
128 KB pages. Channels 5, 6, and 7 transfer 16-bit
WORDs on even byte boundaries only.
DMA Transfer Modes
Each DMA channel can be programmed for single , block ,
demand or cascade transfer modes. In the most commonly
used mode, single transfer mode, one DMA cycle occurs
per DRQ and the PCI bus is released after every cycle.
This allows the Core Logic module to timeshare the PCI
bus with the GX1 module. This is imperative, especially in
cases involving large data transfers, because the GX1
module gets locked out for too long.
Sub-ISA
DMA interface signals are not available externally.
T
CP
www.national.com
PCI