WM8903LGEFK/RV Wolfson Microelectronics, WM8903LGEFK/RV Datasheet - Page 34

• Manufacturer Part Number: WM8903LGEFK/RV
• Description: Audio CODECs ULTRA LOW PWR HI FI CODEC
• Manufacturer: Wolfson Microelectronics

Specifications of WM8903LGEFK/RV

• Audio Codec Type: Stereo Codec
• No. Of Adcs: 2
• No. Of Dacs: 2
• No. Of Input Channels: 6
• No. Of Output Channels: 8
• Adc / Dac Resolution: 24bit
• Sampling Rate: 96kHz
• Operating Temperature Range: -40°C To +85°C
• Rohs Compliant: Yes
• Adcs / Dacs Signal To Noise Ratio: 96dB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WM8903
w
DIFFERENTIAL MICROPHONE INPUT
The Differential Mic PGA configuration is illustrated in Figure 25 for the Left channel. The available
gain in this mode is from +12dB to +30dB in 3dB linear steps. The input impedance is 120kΩ. The
input to the ADC is in phase with the input pin selected by L_IP_SEL_N. The input to the ADC is
phase inverted with respect to the input pin selected by L_IP_SEL_P.
Note that the inverting input pin is selected using L_IP_SEL_P and the non-inverting input pin is
selected using L_IP_SEL_N. This is not the same as for the Differential Line mode.
The equivalent configuration is also available on the Right channel; this can be selected
independently of the Left channel mode.
Figure 25 Differential Microphone Mode
INPUT PGA GAIN CONTROL
The volume control gain for the Left and Right channels be independently controlled using the
LIN_VOL and RIN_VOL register fields as described in Table 3. The available gain range varies
according to the selected PGA Mode as detailed in Table 4. Note that the value ‘00000’ must not be
used in Differential Mic Mode, as the PGA will not function correctly under this setting. In single-
ended mode (L_MODE / R_MODE = 00b), the conversion from single-ended to differential within the
WM8903 adds a further 6dB of gain to the signal path.
Each input channel can be independently muted using LINMUTE and RINMUTE.
It is recommended to not adjust the gain dynamically whilst the signal path is enabled; the signal
should be muted at the input or output stage prior to adjusting the volume control.
Table 3 Input PGA Volume Control
R44 (2Ch)
Analogue Left
Input 0
R45 (2Dh)
Analogue
Right Input 0
REGISTER
ADDRESS
BIT
4:0
4:0
7
7
LINMUTE
LIN_VOL [4:0]
RINMUTE
RIN_VOL [4:0]
LABEL
DEFAULT
00101
00101
1
1
Left Input PGA Mute
0 = not muted
1 = muted
Left Input PGA Volume
(See Table 4 for volume range)
Right Input PGA Mute
0 = not muted
1 = muted
Right Input PGA Volume
(See Table 4 for volume range)
PD, Rev 4.0, September 2010
DESCRIPTION
Production Data
34