XW2Z-200J-B1 Omron, XW2Z-200J-B1 Datasheet - Page 138

• Manufacturer Part Number: XW2Z-200J-B1
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB1

System Setup
Constant Cycle Time Exceeded Flag
Constant Cycle Time Exceeded Error Clear Bit
Constant Cycle Time
Function in Sync
Mode
Constant Cycle Time
Function Enabled for
Coordinator Module
Constant Cycle Time
Function Enabled for
Motion Control Module
Cycle Time Settings
When in Sync Mode with a Sync Cycle Time set for the Coordinator Module
cycle time (default), and the constant cycle time function is used, the cycle
time for Motion Control Modules will be as described below.
The Motion Control Module cycle time is synchronized with the Coordinator
Module constant cycle time, and will therefore be constant.
The Motion Control Module cycle time is synchronized with the Coordinator
Module constant cycle time, and gradually is made constant, while the Motion
Control Module's built-in I/O refresh timing is made constant.
The time from when the processing starts in the Motion Control Module until
the I/O refresh will be constant.
Coordinator
Module
Motion
Control
Module
Timer/Peripheral servicing or
Cycle Time
Constant Cycle Time
Exceeded Flag
Constant Cycle Time
Exceeded Error
Clear Bit
Constant cycle time
Name
Name
Real time
Tab page
Processing
A404.05
A509.15
Address
Address
Constant cycle time
Constant cycle time
Cycle Time
I/O refresh
Real time
Name
Waiting to
synchronize
This flag turns ON when the constant cycle
time function is used and the cycle time
exceeds the constant cycle time set value.
The constant cycle time function can be
enabled again after the cycle time has
exceeded the constant cycle time and A404.05
has turned ON.
0.1 to 100.0 ms,
0.1 ms units
Constant cycle time (enabled)
Real time
Processing
Settings
Description
Description
Constant cycle time
Section 5-6
Variable
I/O refresh
Waiting to
synchronize
Default
115