AT89C5132 Atmel Corporation, AT89C5132 Datasheet - Page 100

• Manufacturer Part Number: AT89C5132
• Manufacturer: Atmel Corporation

Specifications of AT89C5132

• Flash (kbytes): 64 Kbytes
• Max. Operating Frequency: 20 MHz
• Cpu: 8051-12C
• Max I/o Pins: 44
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Uart: 1
• Adc Channels: 2
• Adc Resolution (bits): 10
• Adc Speed (ksps): 22.7
• Sram (kbytes): 2.25
• Self Program Memory: API
• Operating Voltage (vcc): 2.7 to 3.6
• Timers: 2
• Isp: UART/USB
• Watchdog: Yes

100
AT89C5132
Reset Value = 0000 0000b
Table 82. MMINT Register
MMINT (S:E7h Read Only) – MMC Interrupt Register
Number
Number
MCBI
Bit
Bit
4
3
2
1
0
7
7
Mnemonic Description
Mnemonic Description
CRC16S
RESPFS
CRC7S
DATFS
CFLCK
EORI
MCBI
Bit
Bit
6
CRC16 Status Bit
Transmission mode
Set by hardware when the token response reports a good CRC.
Cleared by hardware when the token response reports a bad CRC.
Reception mode
Set by hardware when the CRC16 received in the data block is correct.
Cleared by hardware when the CRC16 received in the data block is not correct.
Data Format Status Bit
Transmission mode
Set by hardware when the format of the token response is correct.
Cleared by hardware when the format of the token response is not correct.
Reception mode
Set by hardware when the format of the frame is correct.
Cleared by hardware when the format of the frame is not correct.
CRC7 Status Bit
Set by hardware when the CRC7 computed in the response is correct.
Cleared by hardware when the CRC7 computed in the response is not correct.
This bit is not relevant when CRCDIS is set.
Response Format Status Bit
Set by hardware when the format of a response is correct.
Cleared by hardware when the format of a response is not correct.
Command FIFO Lock Bit
Set by hardware to signal user not to write in the transmit command FIFO: busy
state.
Cleared by hardware to signal user the transmit command FIFO is available: idle
state.
MMC Card Busy Interrupt Flag
Set by hardware when the card enters or exits its busy state (when the busy
signal is asserted or deasserted on the data line).
Cleared when reading MMINT.
EOCI
5
EOFI
4
F2FI
3
F1FI
2
F2EI
1
4173E–USB–09/07
F1EI
0