h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 113

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

4.1
4.1.1
As table 4.1 indicates, exception handling may be caused by a reset, direct transition, trap
instruction, or interrupt. Exception handling is prioritized as shown in table 4.1. If two or more
exceptions occur simultaneously, they are accepted and processed in order of priority. Trap
instruction exceptions are accepted at all times, in the program execution state.
Exception handling sources, the stack structure, and the operation of the CPU vary depending on
the interrupt control mode set by the INTM0 and INTM1 bits of SYSCR.
Table 4.1
Notes: 1. Traces are enabled only in interrupt control mode 2. Trace exception handling is not
Priority
High
Low
2. Interrupt detection is not performed on completion of ANDC, ORC, XORC, or LDC
3. Trap instruction exception handling requests are accepted at all times in program
Overview
Exception Handling Types and Priority
executed after execution of an RTE instruction.
instruction execution, or on completion of reset exception handling.
execution state.
Exception Type
Reset
Trace *
Direct transition
Interrupt
Trap instruction
(TRAPA) *
Exception Types and Priority
1
3
Section 4 Exception Handling
Start of Exception Handling
Starts immediately after a low-to-high transition at the RES pin,
or when the watchdog overflows. The CPU enters the reset
state when the RES pin is low.
Starts when execution of the current instruction or exception
handling ends, if the trace (T) bit is set to 1
Starts when a direct transition occurs due to execution of a
SLEEP instruction.
Starts when execution of the current instruction or exception
handling ends, if an interrupt request has been issued *
Started by execution of a trap instruction (TRAPA)
Rev. 5.00 Sep 22, 2005 page 87 of 1136
Section 4 Exception Handling
REJ09B0257-0500
2