h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 92

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 2 CPU
2.8.3
The exception-handling state is a transient state that occurs when the CPU alters the normal
processing flow due to a reset, interrupt, or trap instruction. The CPU fetches a start address
(vector) from the exception vector table and branches to that address.
(1) Types of Exception Handling and Their Priority
Exception handling is performed for traces, resets, interrupts, and trap instructions. Table 2.7
indicates the types of exception handling and their priority. Trap instruction exception handling is
always accepted, in the program execution state.
Exception handling and the stack structure depend on the interrupt control mode set in SYSCR.
Table 2.7
Notes: 1. Traces are enabled only in interrupt control mode 2. Trace exception-handling is not
Rev. 5.00 Sep 22, 2005 page 66 of 1136
REJ09B0257-0500
Priority
High
Low
2. Interrupts are not detected at the end of the ANDC, ORC, XORC, and LDC instructions,
3. Trap instruction exception handling is always accepted, in the program execution state.
Exception-Handling State
executed at the end of the RTE instruction.
or immediately after reset exception handling.
Type of Exception
Reset
Trace
Interrupt
Trap instruction
Exception Handling Types and Priority
Detection Timing
Synchronized with clock
End of instruction
execution or end of
exception-handling
sequence *
End of instruction
execution or end of
exception-handling
sequence *
When TRAPA instruction
is executed
1
2
Start of Exception Handling
Exception handling starts
immediately after a low-to-high
transition at the RES pin, or when
the watchdog timer overflows.
When the trace (T) bit is set to 1,
the trace starts at the end of the
current instruction or current
exception-handling sequence
When an interrupt is requested,
exception handling starts at the end
of the current instruction or current
exception-handling sequence
Exception handling starts when a
trap (TRAPA) instruction is
executed *
3