h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 475

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Bit 3—Multiprocessor Interrupt Enable (MPIE): Enables or disables multiprocessor interrupts.
The MPIE bit setting is only valid in asynchronous mode when the MP bit in SMR is set to 1.
The MPIE bit setting is invalid in clocked synchronous mode or when the MP bit is cleared to 0.
Note: * When receive data including MPB = 0 is received, receive data transfer from RSR to RDR,
Bit 2—Transmit End Interrupt Enable (TEIE): Enables or disables transmit end interrupt
(TEI) request generation when there is no valid transmit data in TDR in MSB data transmission.
Note: * TEI cancellation can be performed by reading 1 from the TDRE flag in SSR, then clearing it
Bit 3
MPIE
0
1
Bit 2
TEIE
0
1
receive error detection, and setting of the RDRF, FER, and ORER flags in SSR , is not
performed. When receive data including MPB = 1 is received, the MPB bit in SSR is set to
1, the MPIE bit is cleared to 0 automatically, and generation of RXI and ERI interrupts
(when the TIE and RIE bits in SCR are set to 1) and FER and ORER flag setting is enabled.
to 0 and clearing the TEND flag to 0, or clearing the TEIE bit to 0.
Description
Multiprocessor interrupts disabled (normal reception performed)
[Clearing conditions]
•
•
Multiprocessor interrupts enabled *
Receive interrupt (RXI) requests, receive error interrupt (ERI) requests, and setting
of the RDRF, FER, and ORER flags in SSR are disabled until data with the
multiprocessor bit set to 1 is received.
Description
Transmit end interrupt (TEI) request disabled *
Transmit end interrupt (TEI) request enabled *
When the MPIE bit is cleared to 0
When MPB= 1 data is received
Section 13 Serial Communication Interface (SCI)
Rev. 5.00 Sep 22, 2005 page 449 of 1136
REJ09B0257-0500
(Initial value)
(Initial value)