AMD-766AC AMD [Advanced Micro Devices], AMD-766AC Datasheet - Page 70

• Manufacturer Part Number: AMD-766AC
• Description: Peripheral Bus Controller
• Manufacturer: AMD [Advanced Micro Devices]

23167B – March 2001
PM08: ACPI Power Management Timer
IO mapped (base pointer: C3A58); offset: 0B-08h. Default: 0000 0000h. Read only.
This is either a 24- or a 32-bit counter, based on the state of C3A41[3]. It is a free-running, incrementing counter
clocked off of a 3.579545 MHz clock. It does not count when in the system is in MOFF, SOFF, STD, or STR state.
When the MSB toggles (either bit[23] or bit[31]) then PM00[TMR_STS] is set. This timer is asynchronously cleared
when C3A41[TMRRST] is high.
31:24
ETM_VAL
TMR_VAL. Timer value. This provides the current count of the ACPI power management timer.
ETM_VAL. Extended timer value. If C3A41[3] is high, then these are the 8 MSBs of the ACPI power management
timer. If C3A41[3] is low, then this field always reads back as all zeros.
PM10: Processor Clock Control Register
IO mapped (base pointer: C3A58); offset: 13-10h. Default: 0000 0000h. Read-write.
31:5
Reserved
NTH_RATIO. Normal throttling duty cycle. These specify the duty cycle of the STPCLK# signal to the processor
when the system is in normal throttling mode, enabled by NTH_EN. The field is encoded as follows:
RATIO bits
000b
001b
010b
011b
NTH_EN. Normal throttling enable. 1=Normal throttling (duty cycle specified by NTH_RATIO) is enabled.
Normal throttling is lower priority than thermal throttling (as specified by C3A50); when thermal throttling is
enabled, the throttling duty cycle is specified by C3A50. Throttling is disabled when in the C2, C3, POS, STR, STD,
or SOFF states. 0=Normal throttling is not enabled.
PM14: Processor Level 2 Register
IO mapped (base pointer: C3A58); offset: 14h. Default: 00h. Read only.
7:0
P_LVL2
P_LVL2. Reads from this register initiate the transition of the processor to the C2 state, as specified by C3A50.
This register is byte readable only. Reads from this register always return 00h.
PM15: Processor Level 3 Register
IO mapped (base pointer: C3A58); offset: 15h. Default: 00h. Read only.
7:0
P_LVL3
P_LVL3. Reads from this register initiate the transition of the processor to the C3 state, as specified by C3A50.
This register is byte readable only. Reads from this register always return 00h.
Description
Reserved.
87.5% STPCLK# active.
75.0% STPCLK# active.
62.5% STPCLK# active.
23:0
TMR_VAL
Preliminary Information
RATIO bits
100b
101b
110b
111b
AMD-766
4
NTH_EN NTH_RATIO
Description
50.0% STPCLK# active.
37.5% STPCLK# active.
25.0% STPCLK# active.
12.5% STPCLK# active.
TM
Peripheral Bus Controller Data Sheet
3:1
0
Reserved
70