XC68HC08KH12 Motorola, XC68HC08KH12 Datasheet - Page 120

• Manufacturer Part Number: XC68HC08KH12
• Description: MICROCONTROLLER
• Manufacturer: Motorola

Universal Serial Bus Module (USB)
9.4.1 USB HUB Root Port Control Register (HRPCR)
Advance Information
120
Address:
RESUM0 — Force Resume to the Root Port
SUSPND — USB Suspend Control Bit
Reset:
Read:
Write:
This read/write bit forces a resume signal (“K” state) onto the USB
root port data lines to initiate a remote wakeup. Software should
control the timing of the forced resume to be between 10 ms and 15
ms. Reset clears this bit.
To save power, this read/write bit should be set by the software if at
least 3ms constant idle state is detected on USB bus. Setting this bit
puts the transceiver and regulator into a power savings mode.
This bit also determines the latch scheme for the data lines of the root
port and the downstream port. When this bit is 1, the current state
shown on the data lines will be reflected to the data register (D+/D–)
directly. When the bit is 0, the data registers are the latched state
sampled at the last EOF2 sample point. The hub repeater’s function
is affected by this bit too. The upstream and downstream traffic will be
blocked if this bit is set to 1. When the global resume or the
downstream remote wakeup signal is found by the suspend hub,
software is responsible to propagate the traffic between the root port
and the enabled downstream port by setting the RESUMx control bit.
Reset clears this bit.
Figure 9-2. USB HUB Root Port Control Register (HRPCR)
1 = Force root port data lines to “K” state
0 = Default
$005E
Bit 7
Universal Serial Bus Module (USB)
0
0
= Unimplemented
6
0
0
5
0
0
RESUM0 SUSPND
4
0
X = Indeterminate
3
0
MC68HC(7)08KH12
2
0
0
D0+
X
1
MOTOROLA
—
Rev. 1.0
Bit 0
D0–
X