XC68HC08KH12 Motorola, XC68HC08KH12 Datasheet - Page 216

• Manufacturer Part Number: XC68HC08KH12
• Description: MICROCONTROLLER
• Manufacturer: Motorola

External Interrupt (IRQ)
Advance Information
216
NOTE:
The vector fetch or software clear and the return of the IRQ1/V
logic one may occur in any order. The interrupt request remains pending
as long as the IRQ1/V
and the MODE1 control bit, thereby clearing the interrupt even if the pin
stays low.
If the MODE1 bit is clear, the IRQ1/V
With MODE1 clear, a vector fetch or software clear immediately clears
the IRQ1 latch.
The IRQF1 bit in the ISCR register can be used to check for pending
interrupts. The IRQF1 bit is not affected by the IMASK1 bit, which makes
it useful in applications where polling is preferred.
Use the BIH or BIL instruction to read the logic level on the IRQ1/V
When using the level-sensitive interrupt trigger, avoid false interrupts by
masking interrupt requests in the interrupt routine.
•
•
Vector fetch or software clear — A vector fetch generates an
interrupt acknowledge signal to clear the latch. Software may
generate the interrupt acknowledge signal by writing a logic one to
the ACK1 bit in the interrupt status and control register (ISCR).
The ACK1 bit is useful in applications that poll the IRQ1/V
and require software to clear the IRQ1 latch. Writing to the ACK1
bit prior to leaving an interrupt service routine can also prevent
spurious interrupts due to noise. Setting ACK1 does not affect
subsequent transitions on the IRQ1/V
occurs after writing to the ACK1 bit latches another interrupt
request. If the IRQ1 mask bit, IMASK1, is clear, the CPU loads the
program counter with the vector address at locations $FFFA and
$FFFB.
Return of the IRQ1/V
pin is at logic zero, IRQ1 remains active.
External Interrupt (IRQ)
PP
pin is at logic zero. A reset will clear the latch
PP
pin to logic one — As long as the IRQ1/V
PP
pin is falling-edge-sensitive only.
PP
MC68HC(7)08KH12
pin. A falling edge that
MOTOROLA
PP
—
PP
Rev. 1.0
pin to
PP
pin
pin.
PP