Z8F041APH020SG2156 ZiLOG, Z8F041APH020SG2156 Datasheet - Page 125

• Manufacturer Part Number: Z8F041APH020SG2156
• Description: 8-bit Microcontrollers - MCU 4K FLASH 1K RAM 128B NVDS
• Manufacturer: ZiLOG

Specifications of Z8F041APH020SG2156

• Rohs: yes
• Core: eZ8
• Processor Series: Z8F041xx
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 20 MHz
• Program Memory Size: 4 KB
• Data Ram Size: 1 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2.7 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: PDIP-20
• Mounting Style: Through Hole
• A/d Bit Size: 10 bit
• A/d Channels Available: 8
• Interface Type: UART
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 17
• Number Of Timers: 2
• Program Memory Type: Flash
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.7 V

PS022827-1212
Note:
UART Interrupts
The UART features separate interrupts for the transmitter and the receiver. In addition,
when the UART primary functionality is disabled, the Baud Rate Generator can also func-
tion as a basic timer with interrupt capability.
Transmitter Interrupts
The transmitter generates a single interrupt when the Transmit Data Register Empty bit
(TDRE) is set to 1. This indicates that the transmitter is ready to accept new data for trans-
mission. The TDRE interrupt occurs after the Transmit Shift Register has shifted the first
bit of data out. The Transmit Data Register can now be written with the next character to
send. This action provides 7 bit periods of latency to load the Transmit Data Register
before the Transmit Shift Register completes shifting the current character. Writing to the
UART Transmit Data Register clears the TDRE bit to 0.
Receiver Interrupts
The receiver generates an interrupt when any of the following actions occur:
•
In MULTIPROCESSOR Mode (
multiprocessor configuration and the most recent address byte.
•
•
•
UART Overrun Errors
When an overrun error condition occurs the UART prevents overwriting of the valid data
currently in the Receive Data Register. The Break Detect and Overrun status bits are not
displayed until after the valid data has been read.
After the valid data has been read, the UART Status 0 Register is updated to indicate the
overrun condition (and Break Detect, if applicable). The RDA bit is set to 1 to indicate that
the Receive Data Register contains a data byte. However, because the overrun error
occurred, this byte may not contain valid data and must be ignored. The BRKD bit indi-
cates if the overrun was caused by a break condition on the line. After reading the status
A data byte is received and is available in the UART Receive Data Register. This inter-
rupt can be disabled independently of the other receiver interrupt sources. The received
data interrupt occurs after the receive character has been received and placed in the Re-
ceive Data Register. To avoid an overrun error, software must respond to this received
data available condition before the next character is completely received.
A break is received.
An overrun is detected.
A data framing error is detected.
P R E L I M I N A R Y
MPEN = 1
), the receive data interrupts are dependent on the
Z8 Encore! XP
Product Specification
®
F082A Series
Operation
108