UPD70F3763GC-UEU-AX Renesas Electronics America, UPD70F3763GC-UEU-AX Datasheet - Page 962

• Manufacturer Part Number: UPD70F3763GC-UEU-AX
• Description: MCU 32BIT V850ES/JX3-U 100-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Ur

Specifications of UPD70F3763GC-UEU-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 48MHz
• Connectivity: CSI, EBI/EMI, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

V850ES/JG3-U, V850ES/JH3-U
R01UH0043EJ0300 Rev.3.00
Sep 30, 2010
UF0DMS1
(28) UF0 DMA status 1 register (UF0DMS1)
Remark
Bit position
7, 5, 4, 2
This register indicates the DMA status of Endpoint1 to Endpoint4.
This register is read-only, in 8-bit units.
The related bits are invalid if each endpoint is not supported by the setting of the UF0EnIM register (n = 1 to 4)
and the current setting of the interface.
Each bit is automatically cleared to 0 when this register is read. Even when this register is read, however, bits 4
and 3 of the UF0IS0 register are not cleared to 0.
SET_INTERFACE request, each bit is automatically cleared to 0 by hardware (however, the DMA_END interrupt
request and Short interrupt request are not cleared).
6, 3
n = 1 to 4
m = 2, 4
DEDE4
7
DEDEn
DSPEm
Bit name
DSPE4
6
DEDE3
These bits indicate that the DMA end (TC) signal for Endpoint n becomes active and DMA
is stopped while a DMA read request is being issued from Endpoint n to memory.
These bits indicate that, although a DMA read request was being issued from Endpoint m
to memory, DMA has been stopped because the received data is a short packet and there
is no more data to be transferred.
5
1: DMA end signal for Endpoint n is active.
0: DMA end signal for Endpoint n is inactive (default value).
1: DMASTOP_EPm signal is active.
0: DMASTOP_EPm signal is inactive (default value).
DEDE2
4
DSPE2
3
CHAPTER 20 USB FUNCTION CONTROLLER (USBF)
DEDE1
2
If the target endpoint is no longer supported by the
Function
1
0
0
0
00200050H
Address
Page 962 of 1408
After reset
00H