SPC8106 S-MOS Systems, SPC8106 Datasheet - Page 349

• Manufacturer Part Number: SPC8106
• Description: LCD/CRT VGA CONTROLLER
• Manufacturer: S-MOS Systems

1.0
HOTDISP selects the active display via a Hotkey when both a CRT display and LCD panel are
available.
1.1
1.2
Copy the file hotdisp.exe from the installation diskette to a directory on your hard drive which is
in the DOS path. The directory does not need to be in the path. However, if it is not in the path
then a full path name will have to be specified each time HOTDISP is run.
1.3
HOTDISP may be loaded as as an executable from the DOS command prompt, or as a device
driver from CONFIG.SYS during the boot sequence.
1.3.0.1
To load HOTDISP as a TSR, add the following line to your AUTOEXEC.BAT file or enter it at the
DOS command prompt:
Where:
SPC8106
HOTDISP must to be installed outside a DOS shell. However, once it is installed a hotkey can be
pressed either from a Windows DOS box or Windows DOS full screen to switch the active
display.
411-1.0
Video Controller
Display Type
BIOS
DOS Program
DOS Version
Windows Program
Windows DOS Box
Windows DOS Full Screen : Yes (with limitations), Windows 3.1x and Windows 95 (see note below)
OS/2
hotdisp [/c][/u][/?]
DOCUMENT TITLE VARIABLE
Program Requirements
Installation
Usage
/c
/u
/?
DOS Command Line
S-MOS Systems, Inc. • Tel: [phone] • Fax: [phone] • http://www.smos.com
Changes the hotkey sequence. This switch causes HOTDISP to prompt for the new hotkey
sequence. Press the desired keys in sequence to form a hotkey sequence. A minimum of one to a
maximum of three keys may be used to form the sequence. Use any keys except the following:
Caps Lock, Num Lock, Scroll Lock, Print Screen and Pause/Break.
Removes HOTDISP from Memory.
Displays HOTDISP help message.
: SPC8106, SPC8108
: LCD or CRT
: Seiko Epson VGA BIOS
: Yes
: 2.0 or greater
: No
: Yes (with limitations), Windows 3.1x and Windows 95 (see note below)
: No
X12-UI-014-02
HOTRDISP.EXE Display Utility
UY14-3