r4f2426 Renesas Electronics Corporation., r4f2426 Datasheet - Page 331

• Manufacturer Part Number: r4f2426
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2400 Series
• Manufacturer: Renesas Electronics Corporation.

6.13.2
Even if a bus request is received from a bus master with a higher priority than that of the bus
master that has acquired the bus and is currently operating, the bus is not necessarily transferred
immediately. There are specific timings at which each bus master can relinquish the bus.
(1)
The CPU is the lowest-priority bus master, and if a bus request is received from the DTC, DMAC,
or EXDMAC*, the bus arbiter transfers the bus to the bus master that issued the request. The
timing for transfer of the bus is as follows:
• The bus is transferred at a break between bus cycles. However, if a bus cycle is executed in
• With bit manipulation instructions such as BSET and BCLR, the sequence of operations is:
• If the CPU is in sleep mode, the bus is transferred immediately.
Note: * The EXDMAC is not supported by the H8S/2424 Group.
(2)
The DTC sends the bus arbiter a request for the bus when an activation request is generated.
The DTC can release the bus after a vector read, a register information read (3 states), a single data
transfer, or a register information write (3 states). It does not release the bus during a register
information read (3 states), a single data transfer, or a register information write (3 states).
(3)
The DMAC sends the bus arbiter a request for the bus when an activation request is generated.
In the case of an external request in short address mode or normal mode, and in cycle steal mode,
the DMAC releases the bus after a single transfer.
In block transfer mode, it releases the bus after transfer of one block, and in burst mode, after
completion of the transfer. However, in the event of an EXDMAC or external bus release request,
which have a higher priority than the DMAC, the bus may be transferred to the bus master even if
block or burst transfer is in progress.
discrete operations, as in the case of a longword-size access, the bus is not transferred between
the component operations.
data read (read), relevant bit manipulation operation (modify), write-back (write). The bus is
not transferred during this read-modify-write cycle, which is executed as a series of bus cycles.
CPU
DTC
DMAC
Bus Transfer Timing
Rev. 1.00 Sep. 19, 2008 Page 303 of 1270
Section 6 Bus Controller (BSC)
REJ09B0466-0100