h8s-2649 Renesas Electronics Corporation., h8s-2649 Datasheet - Page 425

• Manufacturer Part Number: h8s-2649
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Figure 13.11 Sample Multiprocessor Serial Transmission Flowchart
Clear DR to 0 and set DDR to 1
Write transmit data to TDR and
Read TDRE flag in SSR
Read TEND flag in SSR
Clear TE bit in SCR to 0
set MPBT bit in SSR
Clear TDRE flag to 0
All data transmitted?
Start transmission
Break output?
Initialization
TDRE = 1
TEND = 1
<End>
Yes
Yes
Yes
Yes
No
No
No
No
[1]
[2]
[3]
[4]
[1] SCI initialization:
[2] SCI status check and transmit
[3] Serial transmission continuation
[4] Break output at the end of serial
Section 13 Serial Communication Interface (SCI)
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a
frame of 1s is output, and
transmission is enabled.
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
flag to confirm that writing is
possible, then write data to TDR,
and then clear the TDRE flag to
0. Checking and clearing of the
TDRE flag is automatic when the
DTC is activated by a transmit
data empty interrupt (TXI)
request, and data is written to
TDR.
transmission:
To output a break in serial
transmission, set the port DDR to
1, clear DR to 0, then clear the
TE bit in SCR to 0.
Rev. 2.00 Dec. 05, 2005 Page 387 of 724
REJ09B0200-0200