MC68HC908AP16CFA MOTOROLA [Motorola, Inc], MC68HC908AP16CFA Datasheet - Page 305

• Manufacturer Part Number: MC68HC908AP16CFA
• Description: Microcontrollers
• Manufacturer: MOTOROLA [Motorola, Inc]

15.8 Interrupts
MC68HC908AP Family — Rev. 2.5
MOTOROLA
NOTE:
slave. This happens because SS at logic 0 indicates the start of the
transmission (MISO driven out with the value of MSB) for CPHA = 0.
When CPHA = 1, a slave can be selected and then later unselected with
no transmission occurring. Therefore, MODF does not occur since a
transmission was never begun.
In a slave SPI (MSTR = 0), the MODF bit generates an SPI
receiver/error CPU interrupt request if the ERRIE bit is set. The MODF
bit does not clear the SPE bit or reset the SPI in any way. Software can
abort the SPI transmission by clearing the SPE bit of the slave.
A logic 1 voltage on the SS pin of a slave SPI puts the MISO pin in a high
impedance state. Also, the slave SPI ignores all incoming SPSCK
clocks, even if it was already in the middle of a transmission.
To clear the MODF flag, read the SPSCR with the MODF bit set and then
write to the SPCR register. This entire clearing mechanism must occur
with no MODF condition existing or else the flag is not cleared.
Four SPI status flags can be enabled to generate CPU interrupt
requests.
SPTE
Transmitter empty
SPRF
Receiver full
OVRF
Overflow
MODF
Mode fault
Freescale Semiconductor, Inc.
For More Information On This Product,
Flag
Go to: www.freescale.com
Table 15-2. SPI Interrupts
SPI transmitter CPU interrupt request
(SPTIE = 1, SPE = 1)
SPI receiver CPU interrupt request
SPI receiver/error interrupt request (ERRIE = 1)
SPI receiver/error interrupt request (ERRIE = 1)
(SPRIE = 1)
Serial Peripheral Interface Module (SPI)
Request
Data Sheet
Interrupts
305