PNX1501E NXP Semiconductors, PNX1501E Datasheet - Page 724

• Manufacturer Part Number: PNX1501E
• Description: Digital Signal Processors & Controllers (DSP, DSC) MEDIA PROCESSOR PNX15XX/266MHZ
• Manufacturer: NXP Semiconductors

Specifications of PNX1501E

• Product: DSPs
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOT-795
• Minimum Operating Temperature: 0 C
• Lead Free Status / Rohs Status: Details
• Other names: PNX1501E,557

Philips Semiconductors
Volume 1 of 1
12NC 9397 750 14321
Product data sheet
5.12.1 Overview
5.12 Receive filtering
In half-duplex mode, when the TxFlowControl bit goes high, continuous preamble is
sent until TxFlowControl is deasserted. If the medium is idle, the LAN100 begins
transmitting its preamble, which raises carrier sense, causing all other stations to
defer. In the event that transmitting the preamble causes a collision, the back
pressure “rides through” the collision. The colliding station backs off, and then defers
to the back pressure. During back pressure, if the user wishes to send a frame, the
back pressure is interrupted, the frame is sent, and then the back pressure is
resumed. If TxFlowControl is asserted for longer than 3.3 ms in 10 Mbps mode or
0.33 ms in 100 Mbps mode, back pressure will cease sending preamble for several
byte times to avoid the jabber limit.
The Ethernet module can filter out receive packets, analyzing the Ethernet
destination address in the packet. This capability greatly reduces the load on the host
system, because the many Ethernet packets that are typically addressed to other
stations would otherwise have to be inspected and rejected by the device driver
software, while using up bandwidth, memory space and host CPU time. Address
filtering can be implemented using the perfect address filter or the (imperfect) hash
filter. The latter produces a 6-bit hash code which can be used as an index into a
64-entry programmable hash table. In addition to the destination address, other
portions of a packet can be included in the filter decision by using a pattern match
filter. The result of the pattern-matching filter can be combined with the address
filtering to create the final filtering result.
The receive filter has two modes:
•
•
AND mode: The AndOr bit of the RxFilterCtrl register is set to 1. The result of the
perfect address filter and the hash filter is ORed into a partial result which is
ANDed with the result of the pattern-matching filter. If the pattern-matching filter
is not enabled, the filter will not pass any packets.
OR mode: The AndOr bit of the RxFilterCtrl register is set to 0. The result of the
perfect address filter and the hash filter is ORed into a partial result which is
ORed with the result of the pattern-matching filter.
Rev. 2 — 1 December 2004
Chapter 23: LAN100 — Ethernet Media Access Controller
© Koninklijke Philips Electronics N.V. 2002-2003-2004. All rights reserved.
PNX15xx Series
23-62