PNX1501E NXP Semiconductors, PNX1501E Datasheet - Page 813

• Manufacturer Part Number: PNX1501E
• Description: Digital Signal Processors & Controllers (DSP, DSC) MEDIA PROCESSOR PNX15XX/266MHZ
• Manufacturer: NXP Semiconductors

Specifications of PNX1501E

• Product: DSPs
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOT-795
• Minimum Operating Temperature: 0 C
• Lead Free Status / Rohs Status: Details
• Other names: PNX1501E,557

Philips Semiconductors
Volume 1 of 1
Table 2:
12NC 9397 750 14321
Product data sheet
Bit
Offset 0x10 3000
31:5
4:1
0
Offset 0x10 300C
31:2
1:0
Offset 0x10 3010
31:29
28:24
23:17
Symbol
Reserved
TOUT_SEL[3:0]
TOUT_OFF
ERR_TOUT_ADDR[31:2]
Reserved
Reserved
ERR_TOUT_GNT[4:0]
Reserved
DCS Controller_TriMedia
3.2 Register Tables
BC_CTRL
BC_ADDR
BC_STAT
Table 2
Acces
s
R/W
R/W
R
R
shows detailed bit locations for each register.
Configuration Registers (Rev 0.32)
Value
-
0x0
0x1
0x00000
000-
-
-
0x0
Rev. 2 — 1 December 2004
Description
Ignore upon read. Write as zeros
Timeout select
0x0 = Timeout generated after 7 consecutive wait cycles.
0x1 = Timeout generated after 7 consecutive wait cycles.
0x2 = Timeout generated after 7 consecutive wait cycles.
0x3 = Timeout generated after 15 consecutive wait cycles.
0x4 = Timeout generated after 31 consecutive wait cycles.
0x5 = Timeout generated after 63 consecutive wait cycles.
0x6 = Timeout generated after 127 consecutive wait cycles.
0x7 = Timeout generated after 255 consecutive wait cycles.
0x8 = Timeout generated after 511 consecutive wait cycles.
0x9 = Timeout generated after 1,023 consecutive wait cycles.
0xa = Timeout generated after 2,047 consecutive wait cycles.
0xb = Timeout generated after 4,095 consecutive wait cycles.
0xc = Timeout generated after 8,191 consecutive wait cycles.
0xd = Timeout generated after 16,383 consecutive wait cycles.
0xe = Timeout generated after 32,767 consecutive wait cycles.
0xf = Timeout generated after 65,535 consecutive wait cycles
Timeout disable
0x0 = Timeout enabled.
0x1 = Timeout disabled.
Full 30 bits of the address which causes an error or timeout.
Ignore upon read. Write as zeroes.
Ignore upon read. Write as zeroes.
Active initiator causing error or timeout -- Initiator ID of the current
pending transaction will be captured:
1: TM3260
2: BOOT
4: PCI
Ignore upon read. Write as zeroes.
© Koninklijke Philips Electronics N.V. 2002-2003-2004. All rights reserved.
PNX15xx Series
Chapter 30: DCS Network
30-4