AT91SAM9G45-EKES Atmel, AT91SAM9G45-EKES Datasheet - Page 609

• Manufacturer Part Number: AT91SAM9G45-EKES
• Description: KIT EVAL FOR AT91SAM9G45
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: MCUr

Specifications of AT91SAM9G45-EKES

• Contents: Board
• Processor To Be Evaluated: SAM9G45
• Data Bus Width: 32 bit
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: - 10 C
• Operating Supply Voltage: 1.8 V to 3.3 V
• For Use With/related Products: AT91SAM9G45
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4626953

33.7.8.19
33.7.8.20
6438F–ATARM–21-Jun-10
LIN Frame Handling
Master Node Configuration
Write IDCHR in US_LINIR to send the header
What comes next depends on the NACT configuration:
• Write TXEN and RXEN in US_CR to enable both the transmitter and the receiver.
• Write USART_MODE in US_MR to select the LIN mode and the Master Node configuration.
• Write CD and FP in US_BRGR to configure the baud rate.
• Write NACT, PARDIS, CHKDIS, CHKTYPE, DLCM, FDIS and DLC in US_LINMR to
• Check that TXRDY in US_CSR is set to “1”
• Case 1: NACT = PUBLISH, the USART sends the response
• Case 2: NACT = SUBSCRIBE, the USART receives the response
• Case 3: NACT = IGNORE, the USART is not concerned by the response
configure the frame transfer.
– Wait until TXRDY in US_CSR rises
– Write TCHR in US_THR to send a byte
– If all the data have not been written, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until RXRDY in US_CSR rises
– Read RCHR in US_RHR
– If all the data have not been read, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until LINTC in US_CSR rises
– Check the LIN errors
AT91SAM9G45
609