S1D13704 Epson Electronics America, Inc., S1D13704 Datasheet - Page 242

• Manufacturer Part Number: S1D13704
• Description: LCD Controller
• Manufacturer: Epson Electronics America, Inc.

Page 10
Installation for CEPC Environment
S1D13704
X26A-E-001-03
Once the NK.BIN file is built, the CEPC environment can be started by booting either from a
floppy or hard drive configured with a Windows 9x operating system. The two methods are
described below.
1. To start CEPC after booting from a floppy drive:
2. To start CEPC after booting from a hard drive:
a. Create a bootable floppy disk.
b. Edit CONFIG.SYS on the floppy disk to contain only the following line:
c. Edit AUTOEXEC.BAT on the floppy disk to contain the following lines:
d. Copy LOADCEPC.EXE and HIMEM.SYS to the bootable floppy disk. Search for
e. Copy NK.BIN to c:\.
f.
a. Copy LOADCEPC.EXE to C:\. Search for the loadCEPC utility in your Windows
b. Edit CONFIG.SYS on the hard drive to contain only the following line:
c. Edit AUTOEXEC.BAT on the hard drive to contain the following lines:
d. Copy NK.BIN and HIMEM.SYS to c:\.
e. Boot the system.
the loadCEPC utility in your Windows CE directories.
Boot the system from the bootable floppy disk.
CE directories.
device=a:\himem.sys
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 c:\nk.bin
device=c:\himem.sys
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 c:\nk.bin
Epson Research and Development
Windows® CE 2.x Display Drivers
Vancouver Design Center
Issue Date: 01/05/25