at85c51snd3 ATMEL Corporation, at85c51snd3 Datasheet - Page 194

• Manufacturer Part Number: at85c51snd3
• Description: At85c51snd3 Single-chip Digital Audio Decoder - Encoder With Usb 2.0 Interface
• Manufacturer: ATMEL Corporation

Command Receiver
194
AT85C51SND3B
Figure 88. Command Transmission Flow
The end of the response reception is signalled by the EORI flag in MMINT register. This
flag may generate an interrupt request as detailed in Section “Interrupt”. When this flag
is set, 2 other flags (RXCEN in MMCON1 register and CRC7S in MMSTA register) give
a status on the response received. RXCEN is cleared when the response format is cor-
rect or not: the size is the one expected (48 bits or 136 bits) and a valid End bit has been
received, and CRC7S indicates if the CRC7 computation is correct or not. The Flag
CRC7S is cleared when a command is sent to the card and updated when the response
has been received.
Response reading may be aborted by setting and clearing the CRPTR bit in MMCON0
register which resets the read pointer to the receive FIFO.
According to the MMC specification delay between a command and a response (for-
mally N
the MMC controller when card does not send its response (e.g. physically removed from
the bus), a time-out timer must be launched to recover from such situation. In case of
time-out the command controller and its internal state machine may be reset by setting
and clearing the CCR bit in MMCON2 register.
This time-out may be disarmed when receiving the response.
CR
parameter) can not exceed 64 MMC clock periods. To avoid any locking of
Configure Response
Transmission
Command
CRCDIS = X
RXCEN = X
RFMT = X
Transmit Command
MMCMD = argument
Load Command in
MMCMD = index
TXCEN = 1
Buffer
7632D–MP3–01/07