UPD78F0413GA-GAM-AX NEC, UPD78F0413GA-GAM-AX Datasheet - Page 490

• Manufacturer Part Number: UPD78F0413GA-GAM-AX
• Description: 8BIT UC, 32K FLASH, 1KB RAM, LCD
• Manufacturer: NEC

Specifications of UPD78F0413GA-GAM-AX

• Controller Family/series: UPD78F
• No. Of I/o's: 30
• Ram Memory Size: 1024Byte
• Cpu Speed: 10MHz
• No. Of Timers: 8
• No. Of Pwm: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 32KB
• Oscillator Type: External, Internal

22.4.1 When used as reset
(1) When detecting level of supply voltage (V
490
When starting operation
When stopping operation
Either of the following procedures must be executed.
<1> Mask the LVI interrupt (LVIMK = 1).
<2> Clear bit 2 (LVISEL) of the low-voltage detection register (LVIM) to 0 (detects level of supply voltage
<3> Set the detection voltage using bits 3 to 0 (LVIS3 to LVIS0) of the low-voltage detection level selection
<4> Set bit 7 (LVION) of LVIM to 1 (enables LVI operation).
<5> Use software to wait for an operation stabilization time (10 s (MAX.)).
<6> Wait until it is checked that (supply voltage (V
<7> Set bit 1 (LVIMD) of LVIM to 1 (generates reset when the level is detected).
Figure 22-5 shows the timing of the internal reset signal generated by the low-voltage detector. The numbers
in this timing chart correspond to <1> to <7> above.
Cautions 1. <1> must always be executed. When LVIMK = 0, an interrupt may occur immediately
When using 8-bit memory manipulation instruction:
Write 00H to LVIM.
When using 1-bit memory manipulation instruction:
Clear LVIMD to 0 and then LVION to 0.
(V
register (LVIS).
DD
)) (default value).
2. If supply voltage (V
after the processing in <4>.
signal is not generated.
CHAPTER 22 LOW-VOLTAGE DETECTOR
DD
)
User’s Manual U18698EJ1V0UD
detection voltage (V
DD
)
DD
)
detection voltage (V
LVI
) when LVIMD is set to 1, an internal reset
LVI
)) by bit 0 (LVIF) of LVIM.