DF3048X16V Renesas Electronics America, DF3048X16V Datasheet - Page 520

• Manufacturer Part Number: DF3048X16V
• Description: MCU 5V 128K,PB-FREE 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of DF3048X16V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 13 Serial Communication Interface
13.3.4
In synchronous mode, the SCI transmits and receives data in synchronization with clock pulses.
This mode is suitable for high-speed serial communication.
The SCI transmitter and receiver share the same clock but are otherwise independent, so full
duplex communication is possible. The transmitter and receiver are also double buffered, so
continuous transmitting or receiving is possible by reading or writing data while transmitting or
receiving is in progress.
Figure 13.14 shows the general format in synchronous serial communication.
In synchronous serial communication, each data bit is placed on the communication line from one
falling edge of the serial clock to the next. Data is guaranteed valid at the rise of the serial clock.
In each character, the serial data bits are transmitted in order from LSB (first) to MSB (last). After
output of the MSB, the communication line remains in the state of the MSB. In synchronous mode
the SCI receives data by synchronizing with the rise of the serial clock.
Communication Format: The data length is fixed at 8 bits. No parity bit or multiprocessor bit
can be added.
Clock: An internal clock generated by the on-chip baud rate generator or an external clock input
from the SCK pin can be selected by clearing or setting the CKE1 bit in SCR. See table 13.9.
When the SCI operates on an internal clock, it outputs the clock signal at the SCK pin. Eight clock
pulses are output per transmitted or received character.
When the SCI operates on an internal clock, the serial clock outputs the clock signal at the SCK
pin. Eight clock pulses are output per transmitted or received character. When the SCI is not
transmitting or receiving, the clock signal remains in the high state. However, when receiving
only, overrun error may occur or the serial clock continues output until the RE bit clears at 0.
When transmitting or receiving in single characters, select the external clock.
Rev. 7.00 Sep 21, 2005 page 494 of 878
REJ09B0259-0700
Synchronous Operation
Serial data
Serial clock
Note:
*
High except in continuous transmitting or receiving
Figure 13.14 Data Format in Synchronous Communication
Don’t care
*
Bit 0
LSB
Bit 1
One unit (character or frame) of serial data
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
MSB
Don’t care
*