EP3C10M164C8N Altera, EP3C10M164C8N Datasheet - Page 125

• Manufacturer Part Number: EP3C10M164C8N
• Description: IC CYCLONE III FPGA 402MHZ BGA-164
• Manufacturer: Altera
• Series: Cyclone IIIr

Specifications of EP3C10M164C8N

• No. Of Logic Blocks: 645
• Family Type: Cyclone III
• No. Of I/o's: 106
• I/o Supply Voltage: 3.3V
• Operating Frequency Max: 402MHz
• Operating Temperature Range: 0°C To +85°C
• Family Name: Cyclone III
• Number Of Logic Blocks/elements: 10320
• # I/os (max): 106
• Frequency (max): 402MHz
• Process Technology: 65nm
• Operating Supply Voltage (typ): 1.2V
• Logic Cells: 10320
• Ram Bits: 423936
• Operating Supply Voltage (min): 1.15V
• Operating Supply Voltage (max): 1.25V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 164
• Package Type: MBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

High-Speed I/O Interface
© December 2009
CIII51008-3.2
f
Altera Corporation
This chapter describes the high-speed differential I/O features and resources in the
Cyclone III device family.
High-speed differential I/O standards have become popular in high-speed interfaces
because of their significant advantages over single-ended I/O standards. The Altera
Cyclone
BLVDS, reduced swing differential signaling (RSDS), mini-LVDS, and point-to-point
differential signaling (PPDS).
This chapter contains the following sections:
■
■
■
■
■
■
Cyclone III device family I/Os are separated into eight I/O banks, as shown in
Figure
LVDS, RSDS, mini-LVDS, and PPDS are on the left and right I/O banks. These I/O
standards are also supported on the top and bottom I/O banks using external
resistors. On the left and right I/O banks, some of the differential pin pairs (p and n
pins) of the true output drivers are not located on adjacent pins. In these cases, a
power pin is located between the p and n pins. These I/O standards are also
supported on all I/O banks using two single-ended output with the second output
programmed as inverted, and an external resistor network. True input buffers for
these I/O standards are supported on all I/O banks.
For more information about the location of Cyclone III device family true differential
pins, refer to the
“High-Speed I/O Interface” on page 7–1
“High-Speed I/O Standards Support” on page 7–7
“True Output Buffer Feature” on page 7–15
“High-Speed I/O Timing” on page 7–16
“Design Guidelines” on page 7–17
“Software Overview” on page 7–18
7–1. Each bank has an independent power supply. True output drivers for
®
III device family (Cyclone III and Cyclone III LS devices) supports LVDS,
Cyclone III Devices Pin-Outs
7. High-Speed Differential Interfaces in
the Cyclone III Device Family
on the Altera website.
Cyclone III Device Handbook, Volume 1
®