IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 23

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

Getting Started—IXB2850
Note:
Note:
2.4.3.2
January 2007
Document Number: 05-2443-006
The first line in the script above loads the baseboard driver. The baseboard driver
operates in one of two modes: with or without the 64-bit prefix used to distinguish
packets coming from or going to the Intel
explained in
By default, the driver works with the prefix enabled. In firmware version 1B2 and later,
when loading the driver, the noFabricPrepend parameter can be used to disable the
use of the prefix. To disable the prefix, change the first line of the script to:
insmod /glc/bb_linux_drv.ko noFabricPrepend=1
The script above shows the
of the
application in an alternate location, for example, in the
other files provided by Intel.
Starting Linux
Configure IXB2850 boards to automatically run the Linux kernel. While in RedBoot*, edit
the configuration file by typing
configuration). The configuration should look like this:
Run script at boot: true
Boot script:
.. load -r -v -m tftp -b 0xd008000 /tftpboot/GLC_BOARD_IP_ADDR/glc/zImage
.. exec
Boot script timeout (1000ms resolution): 3
Use BOOTP for network configuration: true
BOOTP requests numbers <1..30>: 3
GDB connection port: 9000
Use BOOTP for Base Interface #1 network configuration: false
Use BOOTP for Base Interface #2 network configuration: false
Local Base Interface #1 IP address: 0.0.0.0
Local Base Interface #2 IP address: 0.0.0.0
Default Base Interface #1 server IP address: 0.0.0.0
Default Base Interface #2 server IP address: 0.0.0.0
Network debug at boot time: false
Skip POST execution: false
Soft reset: true
SRAM initialization with content: true
5. Configure your file system to start the
6. Copy the
1. Save the configuration and restart the board.
2. After restart, the IXB2850 board should load the Linux kernel from the
boot up.
For example, in the
S70glc
glc
Management PC and use the provided file system. The user should be able to login
as root and start using IXB2850 drivers. To do this, change directory to
sleep 1
/glc/bmcAgent &
/sbin/wtd
modprobe softdog
/glc/glc_start > /dev/console 2> /dev/console
wtd
directory.
application is user-selectable. The user may choose to place the
file that contains:
Section 3.3.1, “Ethernet Packet Formats Over the Backplane” on page
zImage
file with the Linux kernel prepared for the IXB2850 board to the
/etc/rc.d/rc3.d
wtd
fc
application in the
(you can use command
®
glc_start
IXF1104 on the baseboard or FIC as
directory on the root file system, create an
Intel NetStructure
/sbin
script when Linux completes
/glc
directory. The actual location
®
fc –l
.
IXB2850 Packet Processing Boards
directory, which contains
to list the current
wtd
/glc
.
31.
TPS
23