IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 44

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

4.6.1
Table 5.
Note:
Intel NetStructure
TPS
44
®
Multiple FRU Support
The IXB2850 board FRUs visible to the ShMC are listed in
FRUs visible to ShMC
Multiple FRU support is provided according to the following rules:
Text shown in boldface type indicate IPMI commands.
Consult the IPMI v1.5 and the PICMG v3.0 specifications for more information on
“mandatory” and “optional” commands.
FRU ID
00h
01h
02h
03h
04h
05h
06h
07h
• Fiber Media Interface Card (MIC-F)
• Fabric Interface Card (FIC)
• PMC card
• The BMC reports FRUs to the ShMC in response to a Get PICMG Properties
• The Get Address Info command is supported for all FRUs listed in
• Cold reset, triggered by the FRU Control command, is supported only for the
• The Get FRU LED Properties, Get FRU LED State and Set FRU LED State
• All the FRUs listed in
• All sensors are controlled directly by the BMC so that the Get Device Locator ID
IXB2850 Packet Processing Boards
command.
baseboard FRU (ID=00h) and causes a hardware reset of the entire board payload.
commands are supported only for the general status LEDs located on the
baseboard FRU (ID=00h). One exception is the Lamp Test functionality, where
application-specific LEDs are supported also.
are not hot-swappable, therefore the BMC returns the “Not supported (C1h)” code
for the following commands issued for FRUs other than the baseboard FRU:
command is supported only for the baseboard FRU. The “Not supported (C1h)”
code is returned for this command issued for other FRUs.
— Get FRU Activation Policy
— Set FRU Activation Policy
— Set FRU Activation
— Compute Power
— Get Power Level
— Set Power Level
HW module
Baseboard
MMC#1 – Not applicable to IXB2850 boards
MIC#1– Not applicable to IXB2850 boards
MMC#2 – Quad Gigabit Ethernet Mezzanine Card
MIC#2 – Media Interface Card, MIC-F (fiber)
FIC – Fabric Interface Card
NPM – Network Processor Module
PMC – PCI Mezzanine Card
Table
5, with the exception of the baseboard FRU (ID=00h),
IXB2850—Hardware Management
Table
Document Number: 05-2443-006
5.
PICMG Site Type
00h
07h
07h
C7h
C7h
C2h
C0h
08h
Table
January 2007
5.