IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 78

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

6.3
6.3.1
Caution:
6.3.2
Caution:
6.4
Note:
6.5
Caution:
Intel NetStructure
TPS
78
®
Preparing for Installation
It is important to become familiar with the safety aspects and other essential or
national requirements. Before installing the board, read the following chapters in this
manual:
Protecting the Board From Damage
All computer boards are sensitive to electrostatic discharge. Handle all static-sensitive
boards and components at a static-safe work area, and observe anti-static precautions
at all times.
Unpacking the Product
Do not remove the board from the antistatic packaging until you are ready to install it.
Observe proper anti-static precautions at all times. Inspect the packaging for any signs
of damage that may have occurred during transit. In the event of damage or missing
items, notify both the carrier and the supplier immediately.
Installing the Board into a Chassis
The AdvancedTCA standard supports “hot insertion” and “hot swap” of IXB2850 boards.
The chassis can either be powered on or off when inserting the board. The following
procedure describes how to install the board in a live, “hot” system. Installation in a
“cold” system is similar but without the LED indications.
Install the main board in the chassis as follows:
Removing the Board from a Chassis
Remove the board from the chassis as follows:
Do not remove the board until the H/S indicator is lit continuously (that is, not
flashing).
1. Ensure that the board clamps are in the open (unlocked) position (away from the
2. Use the chassis guide rails to carefully align the board’s backplane connectors with
3. Gently insert the board into the chassis backplane.
4. Lock the board clamps.
5. Observe that the blue H/S indicator lights, then after a few seconds it goes out and
6. Press in and tighten both of the board’s front panel retaining screws. When the
1. Loosen both of the board’s front panel retaining screws.
•
•
•
IXB2850 Packet Processing Boards
Chapter 18.0, “Safety Warnings”
Chapter 16.0, “Certifications”
Chapter 17.0, “Agency Information”
front panel).
the AdvancedTCA chassis backplane.
the green HEALTH indicator is lit indicating that the board is now ready for
operation.
screws are tightened, the board should be firmly connected to the chassis
backplane.
IXB2850—Installation and Configuration
Document Number: 05-2443-006
January 2007