atmega32c1 ATMEL Corporation, atmega32c1 Datasheet - Page 17

• Manufacturer Part Number: atmega32c1
• Description: Atmega32m1 Automotive 8-bit Avr Microcontroller With 32k/64k Bytes In-system Programmable Flash
• Manufacturer: ATMEL Corporation

3.8
7647A–AVR–02/08
Reset and Interrupt Handling
Figure 3-4
vard architecture and the fast-access Register File concept. This is the basic pipelining concept
to obtain up to 1 MIPS per MHz with the corresponding unique results for functions per cost,
functions per clocks, and functions per power-unit.
Figure 3-4.
Figure 3-5
operation using two register operands is executed, and the result is stored back to the destina-
tion register.
Figure 3-5.
The AVR provides several different interrupt sources. These interrupts and the separate Reset
Vector each have a separate program vector in the program memory space. All interrupts are
assigned individual enable bits which must be written logic one together with the Global Interrupt
Enable bit in the Status Register in order to enable the interrupt. Depending on the Program
Counter value, interrupts may be automatically disabled when Boot Lock bits BLB02 or BLB12
are programmed. This feature improves software security. See the section
ming” on page 289
The lowest addresses in the program memory space are by default defined as the Reset and
Interrupt Vectors. The complete list of vectors is shown in
determines the priority levels of the different interrupts. The lower the address the higher is the
priority level. RESET has the highest priority, and next is ANACOMP0 – the Analog Comparator
0 Interrupt. The Interrupt Vectors can be moved to the start of the Boot Flash section by setting
the IVSEL bit in the MCU Control Register (MCUCR). Refer to
information. The Reset Vector can also be moved to the start of the Boot Flash section by pro-
Register Operands Fetch
2nd Instruction Execute
3rd Instruction Execute
1st Instruction Execute
ALU Operation Execute
2nd Instruction Fetch
shows the internal timing concept for the Register File. In a single clock cycle an ALU
shows the parallel instruction fetches and instruction executions enabled by the Har-
3rd Instruction Fetch
4th Instruction Fetch
1st Instruction Fetch
Total Execution Time
Result Write Back
The Parallel Instruction Fetches and Instruction Executions
Single Cycle ALU Operation
for details.
clk
clk
CPU
CPU
T1
T1
ATmega32/64/M1/C1
T2
T2
“Interrupts” on page
“Interrupts” on page 55
T3
T3
“Memory Program-
55. The list also
for more
T4
T4
17