UPD78F0138HGK-9ET-A Renesas Electronics America, UPD78F0138HGK-9ET-A Datasheet - Page 194

• Manufacturer Part Number: UPD78F0138HGK-9ET-A
• Description: MCU 8BIT 60K FLASH 64TQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx1+r

Specifications of UPD78F0138HGK-9ET-A

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: 3-Wire SIO, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 42
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

7.4.2 Operation as external event counter
counter 5n (TM5n).
Either the rising or falling edge can be selected.
and an interrupt request signal (INTTM5n) is generated.
192
The external event counter counts the number of external clock pulses to be input to the TI5n pin by 8-bit timer
TM5n is incremented each time the valid edge specified by timer clock selection register 5n (TCL5n) is input.
When the TM5n count value matches the value of 8-bit timer compare register 5n (CR5n), TM5n is cleared to 0
Whenever the TM5n value matches the value of CR5n, INTTM5n is generated.
<1> Set each register.
<2> When TCE5n = 1 is set, the number of pulses input from the TI5n pin is counted.
<3> When the values of TM5n and CR5n match, INTTM5n is generated (TM5n is cleared to 00H).
<4> After these settings, INTTM5n is generated each time the values of TM5n and CR5n match.
Note 8-bit timer/event counter 50: PM17
Setting
TM5n count value
Remark N = 00H to FFH
8-bit timer/event counter 51: PM33
INTTM5n
Set the port mode register (PM17 or PM33)
TCL5n: Select TI5n pin input edge.
CR5n:
TMC5n: Stop the count operation, select the mode in which clear & start occurs on match of TM5n and
Figure 7-12. External Event Counter Operation Timing (with Rising Edge Specified)
CR5n
TI5n
n = 0, 1
TI5n pin falling edge
TI5n pin rising edge
Compare value
CR5n, disable the timer F/F inversion operation, disable timer output.
(TMC5n = 0000
Count start
00H
CHAPTER 7 8-BIT TIMER/EVENT COUNTERS 50 AND 51
01H
02H
00B
TCL5n = 01H
03H
TCL5n = 00H
User’s Manual U16899EJ3V0UD
= Don’t care)
04H
Note
05H
to 1.
N – 1
N
N
00H
01H
02H
03H