h8s-2161b Renesas Electronics Corporation., h8s-2161b Datasheet - Page 509

• Manufacturer Part Number: h8s-2161b
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

11. Clear the IRIC flag to 0.
12. The IRIC flag is set to 1 in either of the following cases.
13. Read the IRTR flag in ICSR.
14. If IRTR flag is 0, clear the IRIC flag to 0 to release the wait state.
15. Clear the WAIT bit in CMR to cancel the wait mode.
16. Read the last ICDR receive data.
17. Clear the BBSY bit and SCP bit to 0 in ICCR. This changes SDA from low to high when SCL
If the IRTR flag is 0, execute step [14] to clear the IRIC flag to 0 to release the wait state.
If the IRTR flag is 1 and data reception is complete, execute step [15] to issue the stop
condition.
Execute step [12] to read the IRIC flag to detect the end of reception.
Then, clear the IRIC flag. Clearing of the IRIC flag should be done while WAIT = 0. (If the
WAIT bit is cleared to 0 after clearing the IRIC flag and then an instruction to issue a stop
condition is executed, the stop condition may not be issued correctly.)
is high, and generates the stop condition.
At the fall of the 8th receive clock pulse for one frame
SCL is automatically fixed low in synchronization with the internal clock until the IRIC
flag is cleared.
At the rise of the 9th receive clock pulse for one frame
The IRTR and ICDRF flags are set to 1, indicating that one frame of data has been
received. The master device outputs the receive clock continuously to receive the next data.
Section 16 I
Rev. 3.00 Mar 21, 2006 page 455 of 788
2
C Bus Interface (IIC) (Optional)
REJ09B0300-0300