PIC18F24J11 MICROCHIP [Microchip Technology], PIC18F24J11 Datasheet - Page 51

• Manufacturer Part Number: PIC18F24J11
• Description: 28/44-Pin, Low-Power, High-Performance USB Microcontrollers with nanoWatt XLP Technology
• Manufacturer: MICROCHIP [Microchip Technology]

4.3
The power-managed Sleep mode is identical to the
legacy Sleep mode offered in all other PIC devices. It is
entered by clearing the IDLEN bit (the default state on
device Reset) and executing the SLEEP instruction.
This shuts down the selected oscillator
clock source status bits are cleared.
Entering the Sleep mode from any other mode does not
require a clock switch. This is because no clocks are
needed once the controller has entered Sleep mode. If
the WDT is selected, the INTRC source will continue to
operate. If the Timer1 oscillator is enabled, it will also
continue to run.
FIGURE 4-5:
FIGURE 4-6:
 2011 Microchip Technology Inc.
Peripheral
Program
Counter
OSC1
Sleep
Clock
Clock
CPU
Note 1: T
CPU Clock
PLL Clock
Peripheral
Program
Sleep Mode
Counter
Output
OSC1
Clock
Q1
Q2
OST
PC
Q3
= 1024 T
Wake Event
Q4
TRANSITION TIMING FOR ENTRY TO SLEEP MODE
TRANSITION TIMING FOR WAKE FROM SLEEP (HSPLL)
Q1
Q1
OSC
T
OST
; T
PLL
(1)
= 2 ms (approx). These intervals are not shown to scale.
(Figure
PC
T
PLL
OSTS Bit Set
(1)
4-5). All
Q2 Q3 Q4 Q1 Q2
PC + 2
PIC18F46J11 FAMILY
When a wake event occurs in Sleep mode (by interrupt,
Reset or WDT time-out), the device will not be clocked
until the clock source selected by the SCS<1:0> bits
becomes ready (see
from the internal oscillator if either the Two-Speed
Start-up or the FSCM is enabled (see
“Special Features of the
OSTS bit is set when the primary clock is providing the
device clocks. The IDLEN and SCS bits are not
affected by the wake-up.
PC + 2
Q3 Q4 Q1 Q2
PC + 4
Figure
Q3 Q4
CPU”). In either case, the
4-6), or it will be clocked
Q1 Q2 Q3 Q4
PC + 6
DS39932D-page 51
Section 26.0