S912XEG128J2MAL Freescale Semiconductor, S912XEG128J2MAL Datasheet - Page 1126

• Manufacturer Part Number: S912XEG128J2MAL
• Description: 16-bit Microcontrollers - MCU 16BIT 128K FLASH 16K RAM
• Manufacturer: Freescale Semiconductor

Specifications of S912XEG128J2MAL

• Rohs: yes
• Core: RISC
• Processor Series: HCS12X
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 128 KB
• Data Ram Size: 12 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT
• A/d Bit Size: 12 bit
• A/d Channels Available: 8
• Data Rom Size: 4 KB
• Interface Type: CAN, I2C, SCI, SPI
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• On-chip Dac: Yes
• Program Memory Type: Flash
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3.13 V

Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
28.4.2.15 Full Partition D-Flash Command
The Full Partition D-Flash command allows the user to allocate sectors within the D-Flash block for
applications and a partition within the buffer RAM for EEPROM access. The D-Flash block consists of
128 sectors with 256 bytes per sector.
1126
1. As defined by the memory map for FTM1024K5.
FERSTAT
Register
FSTAT
Field margin levels must only be used during verify of the initial factory
programming.
Field margin levels can be used to check that Flash memory contents have
adequate margin for data retention at the normal level setting. If unexpected
results are encountered when checking Flash memory contents at field
margin levels, the Flash memory contents should be erased and
reprogrammed.
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Table 28-62. Set Field Margin Level Command Error Handling
Error Bit
FPVIOL
1. Read margin to the erased state
2. Read margin to the programmed state
(CCOBIX=001)
Table 28-61. Valid Set Field Margin Level Settings
0x0002
0x0003
0x0004
CCOB
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:16] is supplied
Set if an invalid margin level setting is supplied
None
None
None
None
CAUTION
NOTE
User Margin-0 Level
Field Margin-1 Level
Field Margin-0 Level
Level Description
Error Condition
(2)
1
2
(1)
Table
28-30)
Freescale Semiconductor