S912XEG128J2MAL Freescale Semiconductor, S912XEG128J2MAL Datasheet - Page 997

• Manufacturer Part Number: S912XEG128J2MAL
• Description: 16-bit Microcontrollers - MCU 16BIT 128K FLASH 16K RAM
• Manufacturer: Freescale Semiconductor

Specifications of S912XEG128J2MAL

• Rohs: yes
• Core: RISC
• Processor Series: HCS12X
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 128 KB
• Data Ram Size: 12 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT
• A/d Bit Size: 12 bit
• A/d Channels Available: 8
• Data Rom Size: 4 KB
• Interface Type: CAN, I2C, SCI, SPI
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• On-chip Dac: Yes
• Program Memory Type: Flash
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3.13 V

26.4.2.9
The Erase P-Flash Block operation will erase all addresses in a P-Flash block.
Upon clearing CCIF to launch the Erase P-Flash Block command, the Memory Controller will erase the
selected P-Flash block and verify that it is erased. The CCIF flag will set after the Erase P-Flash Block
operation has completed.
Freescale Semiconductor
1. As found in the memory map for FTM512K3.
1. As defined by the memory map for FTM512K3.
2. As found in the memory map for FTM512K3.
FERSTAT
FERSTAT
Register
Register
FSTAT
FSTAT
Erase P-Flash Block Command
Table 26-49. Erase P-Flash Block Command FCCOB Requirements
CCOBIX[2:0]
MGSTAT1
MGSTAT0
EPVIOLIF
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
ACCERR
Error Bit
Error Bit
FPVIOL
FPVIOL
Table 26-50. Erase P-Flash Block Command Error Handling
000
001
Table 26-48. Erase All Blocks Command Error Handling
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if any area of the P-Flash memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Set if any area of the buffer RAM EEE partition is protected
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:16] is supplied
Set if an area of the selected P-Flash block is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
Global address [15:0] in P-Flash block to be erased
1
2
0x09
FCCOB Parameters
Error Condition
Error Condition
Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
Global address [22:16] to
identify P-Flash block
(1)
Table
Table
26-30)
26-30)
(1)
(2)
997