M68EVB908GB60E Freescale Semiconductor, M68EVB908GB60E Datasheet - Page 83

• Manufacturer Part Number: M68EVB908GB60E
• Description: BOARD EVAL FOR MC9S08GB60
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of M68EVB908GB60E

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC9S08GB
• Data Bus Width: 8 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08GB
• Kit Contents: GB60 Evaluation Kit
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08GB60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Reads of the data register return the pin value (if PTxDDn = 0) or the contents of the port data register (if
PTxDDn = 1). Writes to the port data register are latched into the port register whether the pin is controlled
by an on-chip peripheral or the pin is configured as an input. If the corresponding pin is not controlled by
a peripheral and is configured as an output, this level will be driven out the port pin.
6.4.1
The data direction control bits determine whether the pin output driver is enabled, and they control what
is read for port data register reads. Each port pin has a data direction control bit. When PTxDDn = 0, the
corresponding pin is an input and reads of PTxD return the pin value. When PTxDDn = 1, the
corresponding pin is an output and reads of PTxD return the last value written to the port data register.
When a peripheral module or system function is in control of a port pin, the data direction control still
controls what is returned for reads of the port data register, even though the peripheral system has
overriding control of the actual pin direction.
For the MC9S08GB/GT MCU, reads of PTG0/BKGD/MS will return the value on the output pin.
It is a good programming practice to write to the port data register before changing the direction of a port
pin to become an output. This ensures that the pin will not be driven momentarily with an old data value
that happened to be in the port data register.
6.4.2
An internal pullup device can be enabled for each port pin that is configured as an input (PTxDDn = 0).
The pullup device is available for a peripheral module to use, provided the peripheral is enabled and is an
input function as long as the PTxDDn = 0.
For the four configurable KBI module inputs on PTA7–PTA4, when a pin is configured to detect rising
edges, the port pullup enable associated with the pin (PTAPEn) selects a pulldown rather than a pullup
device.
6.4.3
Slew rate control can be enabled for each port pin that is configured as an output (PTxDDn = 1) or if a
peripheral module is enabled and its function is an output. Not all peripheral modules’ outputs have slew
rate control; refer to
rate control.
Freescale Semiconductor
Data Direction Control
Internal Pullup Control
Slew Rate Control
Chapter 2, “Pins and
MC9S08GB/GT Data Sheet, Rev. 2.3
Connections” for more information about which pins have slew
Parallel I/O Controls
83